John Deere 522280.13 – BRC: Auxiliary System Fault (Secondary Brake Pressure Not Calibrated)
Issue description
A fault has been detected in the auxiliary brake system indicating that the secondary brake pressure is not calibrated. The sensor measuring pressure in the secondary brake circuit is providing readings outside the expected range, or the Brake Control Unit (BRC) has lost its calibration memory for this sensor. Because the secondary brake system is a critical safety component, this fault can cause the braking system to be derated or rendered completely inoperable until resolved. The display may show messages such as 'Secondary Brake System Not Calibrated' or 'Brake System Inoperable'.
Applies to these machines
10 machines- 8130
- 8230
- 8330
- 8430
- 8530
- 9230
- 9330
- 9430
- 9530
- 9630
Check the cause
Cycle the tractor power using the key switch to see if the intermittent fault clears
Put the vehicle in Park with the engine running and cycle the secondary brake lever
Visually inspect the wiring harnesses and connections between the Brake Control Unit (BRC) and the secondary brake pressure sensor for damage, corrosion, or loose connections
Check for other active fault codes that could pinpoint the root cause, such as sensor voltage codes (BRC 522280.03, BRC 522280.04) or control valve codes (BRC 522279.13)
Repair steps
Perform dealer calibration
The secondary brake pressure sensor must be calibrated by a qualified John Deere dealer using specialized proprietary diagnostic tools and software to set the zero-pressure and known-pressure points.
Replace secondary brake pressure sensor
If calibration fails or the dealer diagnoses a faulty sensor, replace the secondary brake pressure sensor or transducer.
Replace secondary brake switch
If the sensor is functioning but the fault persists, replace the secondary brake switch based on dealer diagnosis.
Replace Brake Control Unit (BRC)
If all external components and wiring are verified and the controller cannot retain calibration, replace the Brake Control Unit.
Parts you might need
(5)- Secondary Brake Pressure SensorRE581543
Fits a wide range of 8030 and 9030 series tractors
Listed specifically for the 8530 model
Brake Pressure Sensor
AT435543Genuine John Deere part recommended
- Secondary Brake SwitchRE265350
Fits 8030 and 9030 series tractors
Brake Control Unit (BRC)
Requires dealer programming
Get help to fix this fault by requesting a quote