John Deere 522575.02 – CSM (Cab Switch Module): Armrest Navigation Bar Fault

Fault in the circuit of button 10 on the navigation bar, indicating erratic, intermittent, or incorrect data usually caused by a physically stuck button, short, or internal electrical failure.

• 6110R
• 6120R
• 6130R
• 6145R
• 6155R
• 6175R
• 6195R
• 6215R
• 8225R
• 8235R
• 8245R
• 8260R
• 8270R
• 8285R
• 8295R
• 8310R
• 8320R
• 8335R
• 8345R
• 8360R
• 8370R
• 8400R

1. 1

   Inspect the shortcut buttons on the navigation bar (under the screen) for physical sticking, dirt, or debris.

2. 2

   Press and release the affected button (Button 10) to attempt to unstick the contact and recover the system.

3. 3

   Turn off the tractor key switch, wait for the display screen to go completely black, and turn it back on to see if the fault clears.

4. 4

   Perform a hard reset of the CommandCenter by holding down the Next Run Page button and the button below it (no icon) simultaneously for five seconds.

5. 5

   Check the wiring harness and connector going to the A048 Armrest Navigation Bar Module for loose connections, moisture intrusion, or damaged pins.

1. 1

   Prepare machine

   Park the machine on a level surface, turn off the engine, and disconnect the battery to prevent electrical shorts.

2. 2

   Remove trim

   Remove the plastic trim/bezel surrounding the CommandCenter display and the navigation bar on the CommandARM.

3. 3

   Disconnect harness

   Unplug the electrical harness connector routed to the back of the navigation bar module.

4. 4

   Remove screws

   Remove the retaining screws securing the A048 Armrest Navigation Bar Module to the CommandARM console.

5. 5

   Replace module

   Extract the faulty module and install the replacement unit.

6. 6

   Reinstall hardware

   Reinstall the retaining screws and reconnect the electrical harness.

7. 7

   Reinstall trim

   Snap the trim/bezel back into place.

8. 8

   Verify repair

   Reconnect the battery, turn the key switch on, and verify that the 522575.02 fault code has moved to a 'stored' state or cleared entirely.