522770.09

John Deere 522770.09 – CSM: Armrest Navigation Bar Module Message Missing

Issue description

Communication failure on the LIN BUS network. The Cab Switch Module is expecting regular status messages from the Armrest Navigation Bar Module, but those messages are missing or timing out.

Applies to these machines

  • 6110R
  • 6120R
  • 6130R
  • 6145R
  • 6155R
  • 6175R
  • 6195R
  • 6215R
  • 8225R
  • 8245R
  • 8270R
  • 8295R
  • 8320R
  • 8335R
  • 8345R
  • 8370R
  • 8400R
  • 9470RT
  • 9520RT
  • 9570RT
  • 3520
  • CH570
  • CH670

Check the cause

  1. Inspect the wiring harness between the Armrest Navigation Bar Module (component A048) and the CSM.

  2. Check for damage or loose connections at the W577 Armrest Navigation Bar Module Extension Harness.

  3. Verify that the Armrest Navigation Bar Module is receiving proper voltage and has a clean ground.

  4. Back-probe the LIN BUS communication wires to check for continuity, ensuring they are not shorted to ground, shorted to power, or suffering from an open circuit.

Repair steps

  1. Power Down

    Turn off the machine and disconnect the negative battery cable to prevent electrical spikes.

  2. Access the Armrest

    Carefully remove the trim panels on the CommandARM console to access the underside of the navigation bar and the CSM.

  3. Inspect and Clean

    Disconnect the plugs at the Armrest Navigation Bar Module and the CSM. Inspect the pins for corrosion, pushed-back pins, or moisture. Clean with contact cleaner and apply dielectric grease.

  4. Repair Wiring

    If the W577 extension harness or main LIN BUS wires are damaged, repair the wires using OEM-approved splicing methods or replace the harness section.

  5. Module Replacement

    If the wiring, power, and ground all test good, the internal LIN transceiver in the Armrest Navigation Bar Module has likely failed. Replace the module.

  6. Reassembly and Clearing

    Reconnect the battery, turn the key to the ON position, and use a diagnostic tool (like John Deere Service ADVISOR) to clear the CSM 522770.09 code. Test the navigation buttons to ensure communication is restored.

Parts you might need

(3)
  • Armrest Navigation Bar Module (Component A048)

    Fitment: CommandARM consoles (8R, 9RT, Harvesters)

  • Cab Switch Module (CSM)

  • W577 Armrest Navigation Bar Module Extension Harness

    Used to bridge the connection within the armrest assembly.

Get help to fix this fault by requesting a quote

Browse other John Deere codes