John Deere 523745.02 – AIC (Armrest Interface Control Unit): iTEC™ Program Selection Switch Logic Fault

The system has detected incorrect switch logic at the switch used for iTEC™ (Intelligent Total Equipment Control / Headland Management) program selection (specifically sequences 1 and 2). As a safety and operational reaction, the control software will limit or completely disable the functionality of the iTEC™ program selection switch.

• 6110R
• 6120R
• 6130R
• 6145R
• 6155R
• 6175R
• 6195R
• 6215R
• 6110M
• 6120M
• 6130M
• 6145M
• 6155M
• 6175M
• 6195M
• 6090MC
• 6090RC
• 6100MC
• 6100RC
• 6110MC
• 6110RC

1. 1

   Examine the iTEC™ Program Selection Switch on the armrest for physical signs of damage, debris, or wear. Ensure that the button moves freely and does not stick in any depressed position.

2. 2

   Utilize John Deere Service ADVISOR™ or a multimeter to test the electrical pathways and connections associated with the switch. Check for shorts, open circuits, or voltage irregularities that could explain the incorrect logic behavior.

3. 3

   Turn the tractor's ignition off and back on to see if the logic fault clears, as it may be a temporary software glitch.

1. 1

   Isolate the Fault

   Based on the electrical test, determine if the fault lies within the wiring harness or the switch module itself.

2. 2

   Repair/Replace

   If the wiring is damaged, repair the harness. If the switch mechanism is faulty or internally shorted, replace the iTEC™ switch module or the affected armrest control module.

3. 3

   Verify Functionality

   After replacing the component, turn on the tractor and conduct tests to ensure the switch correctly activates the intended iTEC™ sequences (1 and 2) without throwing logic errors.

4. 4

   System Reset

   Reset the AIC control system to clear any stored inactive faults and perform comprehensive testing to confirm the iTEC™ system is fully operational.