523786.04

John Deere 523786.04 – SCU / SCC: SCVs I - IV Remote Position Sensor Circuit Voltage Problem

Issue description

The Deluxe Hydraulic Control Unit (SCU) or Supreme Command Controller (SCC) has detected a voltage irregularity in the circuit for the Selective Control Valve (SCV) I-IV remote position sensor. This indicates a potential failure in the sensor, wiring harness, or control unit, which affects the system's ability to monitor and control the hydraulic valves.

Applies to these machines

  • 9230
  • 9330
  • 9430
  • 9530
  • 9630
  • 7720
  • 7820
  • 7920
  • 7630
  • 7730
  • 7830
  • 7930
  • 9R
  • 9RT
  • 9RX
  • 7R
  • 8R
  • 8RT
  • 8RX

Check the cause

  1. Restart the tractor to see if the communication error clears on its own

  2. Inspect SCV hydraulic hoses to ensure they are connected correctly and not reversed, which can lead to fault conditions

  3. Check fuse F30, which is related to SCV solenoid voltage issues

  4. Visually inspect the area around the batteries and alternator for any visible signs of damage or debris accumulation

Repair steps

  1. Run system diagnostics

    Connect the John Deere Service ADVISOR™ diagnostic tool to read specific fault details and run system tests.

  2. Test wiring harness

    Test the wiring harness and connectors between the SCU and the relevant SCV position sensor for continuity, shorts, or high resistance.

  3. Test position sensor

    Test the SCV position sensor itself to confirm if it is faulty and causing the irregular voltage readings.

  4. Replace faulty components

    If the sensor is identified as the cause, replace it. If the sensor and wiring are intact, the SCV Electronic Control Unit may need replacement.

  5. Calibrate hydraulic system

    Following the replacement of the sensor or control unit, perform a system calibration using the Service ADVISOR™ tool.

Parts you might need

(8)
  • Compatible with 7R, 8R, 8RT, 8RX, 9R, 9RT, and 9RX series tractors

  • General position sensor

  • Rotary Position Sensor

    RE53380

    Substitute part RE261357

  • Shaft, Position Sensor With Arm

    RE344121

    Compatible with 9R series tractors

  • SCV Electronic Control Unit

    RE567605

    Compatible with 8R, 9R, 9RT, 9RX series tractors

  • Compatible with 9230, 9330, 9430, 9530, 9630 tractors

  • Compatible with 9230, 9330, 9430 tractors

Get help to fix this fault by requesting a quote

Browse other John Deere codes