John Deere 523795.02 – SSU: Electro-hydraulic Valve Plumbings Incorrect
Issue description
The hydraulic hoses connected to the electro-hydraulic (EH) steering valve are plumbed backwards. Specifically, the left and right workport connections are reversed. This reversal causes improper operation of the AutoTrac steering system and is often detected and logged by the Steering System Unit (SSU) during a calibration attempt.
Applies to these machines
13 machines- 6020 Series
- 6920S
- SE Series
- 7225J
- 9x30 Series
- 8R Series
- W-Series Windrowers
- 4730 Sprayer
- 4830 Sprayer
- 4920 Sprayer
- 4930 Sprayer
- 7J Series
- 9000 Series
Check the cause
Shut down the engine and relieve all hydraulic pressure for safety before inspection
Locate the EH AutoTrac valve, which is typically found under the tractor cab
Inspect the hydraulic hose connections and compare them to the machine-specific installation instructions or hydraulic diagrams, specifically checking if the left and right workport hoses are switched
Check for any signs of hydraulic fluid leaks from the fittings or the valve body
Repair steps
Relieve hydraulic pressure
Ensure the machine is off and hydraulic pressure is fully relieved to prevent serious injury.
Correct the plumbing
Identify the reversed hydraulic hoses on the EH steering valve. Disconnect the fittings, swap them to their correct ports on the valve block, and tighten to the proper torque specification.
Clean the Area
After correcting the connections, clean any spilled hydraulic oil from the valve and surrounding area.
Reconnect Electricals
Ensure the electrical connector is securely fastened to the valve.
System Calibration
After the valve plumbing has been corrected or a new valve has been installed, a calibration of the steering system is required. This procedure is typically initiated through the machine's display. For some systems, this involves navigating to a specific menu and holding a button to start the calibration process, during which the system will measure the steering's range of motion.
Verify operation
After calibration, operate the machine and the AutoTrac system to ensure the fault code does not reappear and the steering functions correctly.
Parts you might need
(4)- AutoTrac Steering Control ValveRE326796
Compatible with 8R Series tractors and W-Series Windrowers
AutoTrac Steering Control Valve
AN207462Compatible with 4730, 4830, 4920, and 4930 Sprayers
Compatible with 7J, 8R, 9000 series, and 7225J
General application, verify fitment with dealer
Get help to fix this fault by requesting a quote