523795.02

John Deere 523795.02 – SSU: Component Identification Required

Issue description

The system has detected that the flow of hydraulic fluid is reversed from the expected direction for a given steering command. This indicates an improper physical or hydraulic connection of the electro-hydraulic steering valve, which is a component of the AutoTrac assisted steering system. In some instances, this fault may also be triggered during the calibration of the electro-hydraulic steering valve.

Applies to these machines

  • 7630
  • 7730
  • 7830
  • 7930
  • 9230
  • 9330
  • 9430
  • 9530
  • 9630

Check the cause

  1. Verify the fault code SSU 523795.02 is active or stored on the tractor's display

  2. Visually inspect the hydraulic connections at the AutoTrac steering valve to see if the workport hoses are reversed

  3. Check for any other active SSU or AutoTrac related fault codes (e.g., steering valve calibration, voltage, or sensor signals) for additional diagnostic context

  4. Review system calibration history to determine if the fault appeared after a component replacement or a calibration attempt

Repair steps

  1. Prepare machine for service

    Park the machine on a level surface, shut down the engine, and relieve any residual hydraulic pressure.

  2. Locate the steering valve

    Find the AutoTrac steering valve, which is typically located underneath the front axle on the inside of the frame rail.

  3. Correct hydraulic connections

    Identify the workport hydraulic lines connected to the electro-hydraulic steering valve. Swap the connections to their correct ports.

  4. Clear fault codes

    Once the connections are corrected, clear the diagnostic trouble codes from the SSU.

  5. Perform AutoTrac calibration

    Initiate a calibration of the AutoTrac system through the machine's display to ensure the SSU recognizes the correct valve orientation. Follow on-screen instructions. Perform this in a safe, open area as the machine may move unpredictably.

  6. Test operation

    Operate the tractor and engage the AutoTrac system to verify that the steering functions correctly and the fault code does not reappear.

Parts you might need

(4)

Get help to fix this fault by requesting a quote

Browse other John Deere codes