ACU523805.03

John Deere ACU523805.03 – ACU: One Lever Control Problem

Issue description

The Armrest Control Unit (ACU) has detected a malfunction within the single-lever control system (CommandARM™ joystick). The ACU is not receiving the expected signals from the single-lever control, which prevents it from properly commanding hydraulic functions. This issue primarily affects the functionality of Selective Control Valves (SCVs) III and IV.

Applies to these machines

  • 7630
  • 7730
  • 7830
  • 7930
  • 8130
  • 8230
  • 8230T
  • 8330
  • 8330T
  • 8430
  • 8430T
  • 8530
  • 9330
  • 9430
  • 9530
  • 9630
  • 7720
  • 7820
  • 7920

Check the cause

  1. Restart the tractor to see if resetting communication messages clears the fault

  2. Verify operator presence and ensure the hand presence switch is correctly engaged

  3. Check fuses F22 and F24 related to CAB and ECU communication

  4. Visually inspect batteries and alternator for damage or debris, as low voltage can cause electronic faults

Repair steps

  1. Restart tractor

    Restart the engine to reset communication messages between the control units. This can sometimes clear the fault if it was a temporary glitch.

  2. Verify hand presence switch

    Ensure the operator's hand is correctly positioned to engage the hand presence switch on the joystick.

  3. Inspect fuses and power supply

    Check fuses F22 and F24. Inspect the batteries and alternator to ensure proper system voltage is being supplied to the ACU.

  4. Perform sensor circuit test

    If the fault persists, consult the Service ADVISOR™ manual (TM2254) to perform the 'ACU - Fore - Aft Single Lever Control Sensor Circuit Test'. This will guide the diagnosis of the joystick's sensor circuits and wiring.

  5. Replace faulty components

    Based on the circuit test results, replace the single-lever control assembly, wiring harness, or the Armrest Control Unit as necessary.

Parts you might need

(6)
  • Single-Lever Control for CommandARM™ (Joystick) Kit

    AR243091

    Complete assembly including control, wiring, and bracket. Compatible with 7030, 8030 series tractors and others. Requires the tractor to have four SCVs.

  • Single-Lever Control for CommandARM™ (Joystick) Kit

    AR272536

    Complete assembly including the control, wiring, and bracket.

  • Fits a wide range of John Deere tractors, including the 7020, 7030, and 8030 series.

  • CommandARM™ Joystick Handle

    AXE21044

    OEM John Deere

  • REMAN Armrest Control Panel Circuit Board

    RM100032

    Remanufactured John Deere part

  • Remanufactured John Deere part

Get help to fix this fault by requesting a quote

Browse other John Deere codes