John Deere 523813.11 – RPT (Rear Chassis): Solenoid for PTO Speed 1, Fault

The system detects a circuit fault in the solenoid responsible for PTO speed 1, typically a shorted circuit, an open circuit, or an overheating solenoid, causing the rear PTO to be significantly limited or entirely non-functional.

• 6110R
• 6120R
• 6130R
• 6145R
• 6155R
• 6175R
• 6195R
• 6215R

1. 1

   Visually and physically inspect the wiring harness and connections leading to the PTO speed 1 solenoid for signs of a short, open circuit, or heat damage

2. 2

   Measure current and voltage levels at the PTO speed 1 solenoid using a multimeter to ensure they are within the specified operating range

3. 3

   Actively test the solenoid for proper operation using John Deere Service ADVISOR diagnostic tools

4. 4

   Check if the PAP control software is updated to the latest version to rule out false circuit faults

1. 1

   Wiring Repair

   If the diagnostic checks reveal damaged wires or connectors, repair or replace the affected sections of the wiring harness.

2. 2

   Solenoid Replacement

   If the wiring and voltage are correct but the solenoid fails the operational test or is physically overheating, remove and replace the faulty PTO solenoid valve.

3. 3

   Software Update

   Apply any available software updates to the PAP control module.

4. 4

   Clear and Verify

   Clear the RPT 523813.11 fault code from the system and test the rear PTO engagement to verify the repair.