John Deere BRC523837.04 – BRC: Rear Brake Pressure Circuit Problem
Issue description
The Brake Control Unit (BRC) has detected a malfunction within the electrical circuit that monitors the hydraulic pressure for the rear brakes. The .04 suffix indicates that the circuit voltage is below normal or shorted to a low source.
Applies to these machines
22 machines- 7R Series
- 8R Series
- 8RT Series
- 9R Series
- 9RT Series
- 7020 Series
- 7720
- 7820
- 7920
- 7030 Series
- 7630
- 7730
- 7830
- 7930
- 9030 Series
- 9230
- 9330
- 9430
- 9530
- 9630
- 7210J
- 7810
Check the cause
Restart the machine to see if the diagnostic trouble code clears and resets communication messages
Carefully inspect the area around the batteries and alternator for any signs of damage, corrosion, or loose connections
Check the condition of fuses related to the brake control system, specifically fuses F30 and F24 for BRC supply voltage
Repair steps
Read live sensor data
Use John Deere Service ADVISOR software to read live data from the rear brake pressure sensor to verify its output.
Test wiring harness
Test the wiring harness between the rear brake pressure sensor and the BRC controller for continuity and shorts to ground.
Replace faulty component
Based on diagnostic findings, replace the rear brake pressure sensor (most probable cause), repair the wiring harness, or replace the BRC controller if the sensor and wiring are confirmed to be in good condition.
Parts you might need
(5)- Rear Brake Pressure SensorRE584417
Listed for 7R, 8R, and 9R series tractors. Substitutes TA13485.
Rear Brake Pressure Sensor
AT435543General brake pressure sensor for heavy-duty equipment.
- Rear Brake Pressure SensorTA13485
Substituted by RE584417.
Brake Control Unit (BRC)
Part number is dependent on the specific tractor model.
Wiring Harness
Repair or replace affected section if a short or open circuit is found.
Get help to fix this fault by requesting a quote