CCU523916.15

John Deere CCU523916.15 – CCU: Hydraulic Filter Replacement Required

Issue description

The Central Control Unit (CCU) has detected an elevated pressure differential across the hydraulic oil filter via the restriction sensor. This indicates that the flow of hydraulic oil is impeded, typically due to a clogged or dirty filter that has reached the end of its service life. If the filter is not restricted, this code can also be triggered by a malfunctioning hydraulic filter restriction sensor sending an incorrect signal to the CCU.

Applies to these machines

  • 7200R
  • 7215R
  • 7230R
  • 7260R
  • 7280R
  • 8225R
  • 8235R
  • 8245R
  • 8260R
  • 8270R
  • 8285R
  • 8295R
  • 8310R
  • 8320R
  • 8335R
  • 8345R
  • 8360R
  • 8370R
  • 8400R
  • 8225RT
  • 8235RT
  • 8245RT
  • 8260RT
  • 8270RT
  • 8285RT
  • 8295RT
  • 8310RT
  • 8320RT
  • 8335RT
  • 8345RT
  • 8360RT
  • 8370RT
  • 8400RT
  • 9360R
  • 9410R
  • 9460R
  • 9510R
  • 9560R
  • 9360RT
  • 9410RT
  • 9460RT
  • 9510RT
  • 9560RT
  • 8130
  • 8230
  • 8330
  • 8430
  • 8530

Check the cause

  1. Verify the maintenance schedule and tractor service history to determine when the hydraulic filters were last replaced (typical interval is 1500 hours).

  2. Inspect the hydraulic oil level and condition, looking for contamination or signs of high temperatures that can contribute to filter restriction.

  3. Clear the Code: After replacing the filters, clear the fault code and operate the machine to see if the code returns. If it does, it is highly indicative of a sensor issue.

Repair steps

  1. Replace Hydraulic Filters

    Replace the hydraulic oil filters. On many 8R series tractors, there are two hydraulic filters that should be replaced simultaneously.

  2. Inspect and Replace the Sensor (If Necessary)

    If the fault code reappears after filter replacement, replace the Transmission Differential Pressure Sensor located on the inner side of the hydraulic and transmission filter housing. Disconnect the electrical connector, unscrew the old sensor, install the new sensor ensuring it is properly seated and tightened, and reconnect the electrical connector.

  3. Final Verification

    After completing the repair, operate the tractor to ensure the fault code does not return.

Parts you might need

(2)

Get help to fix this fault by requesting a quote

Browse other John Deere codes