John Deere ACU524024.31 – ACU: Left Reverse Problem
Issue description
The system has detected an issue within the left-hand reverser control system. Logged by the Armrest Control Unit (ACU), this fault indicates a condition that prevents the proper operation of the reverse function as commanded by the operator via the left-hand reverser lever.
Applies to these machines
17 machines- 7630
- 7730
- 7830
- 7930
- 8130
- 8230
- 8330
- 8430
- 8530
- 9230
- 9330
- 9430
- 9530
- 9630
- 7720
- 7820
- 7920
Check the cause
Restart the tractor with the reverser lever in the PARK position to see if the fault clears (often resolves intermittent communication issues)
Review the CommandCenter for any other active diagnostic trouble codes, particularly communication errors that point to a broader electrical issue
Inspect the 8-pin electrical connector at the armrest for any signs of corrosion, pushed-back pins, or loose connections, and inspect the harness running down the steering column for any damage
Verify relevant fuses, such as fuse F24 (associated with the ECU), which could lead to communication issues with the ACU
Check mechanical linkages in the shifter mechanism for loose screws, excessive play, or worn bushings and gears
Test the ACU power supply voltage (should be 12.5-14.5 V) and the ground circuit resistance (should be below 1.0 ohm)
Repair steps
Identify faulty component
Based on diagnostic findings, determine if the fault lies with the left-hand reverser lever assembly, the Armrest Control Unit (ACU), or the wiring harness.
Replace left-hand reverser lever
If the lever assembly is diagnosed as faulty, remove the steering wheel and steering column covers to access the reverser mechanism and its electrical connector, then replace the assembly.
Replace Armrest Control Unit (ACU)
If the ACU itself is determined to be the issue, replace the control board located within the armrest console.
Calibrate and program system
After replacing a major electronic component like the ACU, have a dealer perform a calibration or programming procedure to ensure it communicates correctly with the tractor's other control modules.
Parts you might need
(5)- Armrest Control Unit (ACU)RE239078
Supersedes RE182547, RE231729. Remanufactured version RM100030 may also be available.
Verify exact part by tractor serial number and transmission type.
Verify exact part by tractor serial number and transmission type.
Replaced by AL231684. Verify exact part by tractor serial number and transmission type.
Verify exact part by tractor serial number and transmission type.
Get help to fix this fault by requesting a quote