John Deere 524234.03 – PTQ, PTR, or EPC: Transmission Enable Sensor, Voltage Too High
Issue description
The control software detects a voltage above 4.875 volts at the transmission enable sensor for more than 960 milliseconds (enable pressure above 2000 kPa / 290 psi), indicating either a circuit problem such as a short to a high voltage source or an actual excessive enable pressure condition.
Applies to these machines
49 machines- 6110M
- 6120M
- 6130M
- 6145M
- 6155M
- 6175M
- 6195M
- 6110R
- 6120R
- 6130R
- 6145R
- 6155R
- 6175R
- 6195R
- 6215R
- 5045E
- 5055E
- 5065E
- 5075E
- 5085E
- 5090E
- 5100E
- 5085M
- 5090M
- 5095M
- 5100M
- 5105M
- 5115M
- 5080R
- 5090R
- 5100R
- 4044M
- 4044R
- 4049M
- 4049R
- 4052M
- 4052R
- 4066M
- 4066R
- 6230
- 6330
- 6430
- 7630
- 7720
- 7730
- 7820
- 7830
- 7920
- 7930
Check the cause
Restart the engine to verify if the active Service Code reappears, as a system reset can sometimes correct communication messages
Inspect the wiring harness and connectors associated with the transmission enable sensor (Component B105) for security, corrosion, and visible damage
Inspect the circuit for any signs of shorted connections to a high-voltage source or damaged wires
Use a multimeter to measure the voltage at the transmission enable sensor signal input to confirm if it is genuinely outputting greater than 4.875 volts
Verify that the transmission control software is up-to-date
Repair steps
Power Down
Turn off the tractor and disconnect the battery to ensure safety while working on the transmission electrical circuits.
Locate Sensor B105
Locate the Transmission Enable Pressure Sensor (designated as B105 in John Deere schematics) on the transmission valve body/housing.
Harness Repair
If the diagnostic checks revealed chafed wires or a short to power in the B105 circuit, repair the wiring harness or replace the damaged connector.
Sensor Replacement
If the wiring is intact but the sensor internally shorts or continuously reads above 2000 kPa (290 psi) / 4.875V, the sensor is defective. Remove the old sensor and install the replacement.
Reassemble and Clear Codes
Reconnect the battery, turn on the tractor, and use the CommandCenter or a John Deere diagnostic tool to acknowledge and clear the stored 524234.03 code.
Test Operation
Test the transmission enable sensor by operating the tractor to ensure proper functionality and confirm that the voltage at the signal input remains within the specified normal range.
Parts you might need
(1)Transmission Enable Sensor / Enable Pressure Sensor (Component B105)
Specific OEM part numbers vary heavily by the exact tractor model and transmission option. Provide the dealer with your tractor's PIN/Serial Number to ensure you get the correct B105 pressure sensor for your specific transmission module (PTQ, PTR, or EPC).
Get help to fix this fault by requesting a quote
