CCU524251.31

John Deere CCU524251.31 – CCU: Return to Seated Position

Issue description

The Central Control Unit (CCU) has received a command to perform a function that requires operator presence (such as engaging the PTO, using AutoTrac, or operating certain hydraulic functions), but the operator presence switch indicates that the operator is not seated. One specific condition that can trigger this code is having the rear PTO active while the operator is out of the seat. If the operator is already seated when this code appears, it signifies a fault within the operator presence detection system.

Applies to these machines

  • 7000 Series
  • 8000 Series
  • 9000 Series
  • 8120
  • 8420
  • 8R

Check the cause

  1. Return squarely to the operator's seat and cycle the key switch to see if the code clears

  2. Perform a functional system check via the corner post display (navigate to ACU controller, address 19). The value should show 001 when seated and cycle to 000 when out of the seat

  3. Check for a bypassed switch (jumper wire or modified connector) plugged into the seat switch wiring harness at the back of the seat

  4. Visually inspect the underside of the seat cushion for broken plastic components around the switch mounting (a common failure point)

  5. Inspect the wiring harness leading to the seat switch for any signs of damage, chafing, or loose connections

  6. Perform an electrical check on the switch with a multimeter. It should be normally open (no continuity) and show continuity only when the plunger is depressed

Repair steps

  1. Confirm the fault

    Use the diagnostic checks above to confirm whether the fault is with the switch, its mounting, or the wiring.

  2. Access the switch

    Tilt the operator's seat forward to access the switch and its connector on the underside of the seat pan.

  3. Address a bypassed switch

    If a jumper wire is found, remove it and reconnect the seat harness to the switch. If the original problem returns, proceed to diagnose the switch or its mounting.

  4. Repair broken mounting

    If the plastic mounting molded inside the seat cushion is broken, the official repair is to replace the entire seat cushion.

  5. Replace the seat switch

    Disconnect the electrical connector from the switch. Remove the switch (often held in place by rotating it or depressing tabs). Install the new switch, reconnect the wiring harness, and test for proper operation using diagnostic address ACU 19 or by verifying that the fault code clears and machine functions are restored.

Parts you might need

(4)
  • For 7000-9000 series tractors. Verify fitment by serial number.

  • For 7000-9000 series tractors. Verify fitment by serial number.

  • Seat CushionRE163027

    Example part number. Required if the plastic switch mounting is broken.

  • Seat CushionRE263084

    Example part number. Required if the plastic switch mounting is broken.

Get help to fix this fault by requesting a quote

Browse other John Deere codes