John Deere 000598.02 – ECM / PTP / PTR / EPC: Clutch Pedal Sensor Issue Detected

The Main Control Module has detected an issue with the Clutch Pedal Sensor or its circuit. This rotary position sensor is responsible for detecting the position, angle, or movement of the clutch pedal. A fault is triggered when the control unit receives an unexpected or illogical signal, indicating a circuit conflict, a problem with the sensor's operation, or an issue with its connection to the system.

• 5085E
• 5090E
• 5090EL
• 5100E
• 5045D
• 5050E
• 5055E
• 5058E
• 5060E
• 5065E
• 5067E
• 5075E
• 5082E
• 5083EN
• 5093EN
• 5101EN
• 5225
• 5325
• 5325N
• 5425
• 5425N
• 5525
• 5525HC
• 5525N
• 5625
• 5725
• 5603
• 6140R
• 7200R
• 8225R
• 9360R
• 2704
• 2854
• 2904
• 3004
• 3204
• 6020
• 7010
• 7020
• 8020
• 8030
• 9020

1. 1

   Inspect the wiring harness and connectors associated with the clutch pedal sensor, particularly near the main control module, for damage, corrosion, or loose connections.

2. 2

   Check for other active fault codes that may indicate a related issue, such as a problem with the 5-volt sensor power supply.

3. 3

   Attempt to calibrate the control unit to see if it resolves the issue.

4. 4

   Perform an in-depth electrical circuit test of the rear hitch position sensor circuit if the calibration fails.

1. 1

   Confirm the fault

   After performing initial diagnostic checks, verify if the code returns to confirm the problem is with the sensor or wiring.

2. 2

   Repair wiring

   Repair or replace any damaged wiring or corroded connectors found during the inspection.

3. 3

   Replace the sensor

   If the wiring is intact and the fault persists, replace the clutch pedal position sensor with a new OEM part.

4. 4

   Clear codes

   Use a diagnostic tool to clear the fault code from the control module's memory after the repair is complete.

5. 5

   Re-calibrate and test

   Perform any necessary control unit calibrations and operate the machine to ensure the fault does not return.