000628.02

John Deere 000628.02 – CCU / BIF / FCC: Controller Internal Fault During Boot-Up

Issue description

This is a generic diagnostic trouble code indicating an internal fault within one of several possible electronic control modules (such as the ACU, BIF, EIC, or FCC). It signifies a general error within the controller itself, such as a configuration data issue, programming mode problem, or an end-of-line (EOL) data fault. Depending on the affected module, this can result in limited engine power or restricted system functions.

Applies to these machines

  • 6105M
  • 6110M
  • 6120M
  • 6130M
  • 6145M
  • 6155M
  • 6175M
  • 6195M
  • 7420
  • 6020
  • 6120
  • 6220
  • 6320
  • 6420
  • 6420S
  • 6510
  • 6610
  • 6810
  • 6910
  • 5000 E Series

Check the cause

  1. Cycle the key switch (power cycle) to see if the fault clears

  2. Check the battery and connections to ensure the battery is fully charged and terminals are clean and tight (low system voltage during startup can trigger spurious internal module faults)

  3. Visually inspect the wiring harness and connectors leading to the identified control module (CCU, BIF, or FCC) for damage, corrosion, or loose connections

  4. Verify if the fault appeared after a recent reprogramming attempt, which may indicate the process was unsuccessful

Repair steps

  1. Identify the faulting controller

    Check the prefix on the diagnostic display (e.g., CCU, BIF, or FCC) to determine which specific module is logging the fault.

  2. Perform basic diagnostics and clean contacts

    Carry out a power cycle and battery check. If inspecting the wiring reveals corrosion or poor connections, clean the ECU contacts and apply dielectric grease.

  3. Reprogram the control unit

    If the fault is related to a recent reprogramming attempt, have a qualified technician reprogram the control unit using the appropriate John Deere diagnostic tools.

  4. Replace the control module

    If basic diagnostics and reprogramming do not resolve the issue, the internal fault is likely permanent. Replace the affected control module with the correct part number for the specific machine configuration. The new module may require dealer programming.

Parts you might need

(8)
  • Verify fit for the specific tractor model and serial number.

  • Front Chassis Control Unit (FCC)

    AL214931

    Substitute for AL211997. Fits 6105M with TLS/Front PTO.

  • Basic Informator (BIF) LCD Display

    AW-LCD-486

    Third-party part fitting John Deere 7420 IVT display.

  • Fits various 6010 series tractors

  • Mentioned in the context of BIF repair

  • Front Chassis Control Unit

    AL206359

    Replaces AL206358. Fits various 7R, 7200R, 7215R, 8235R series tractors

  • Chassis and Spray Control Unit

    AN207245
  • PowerShift Transmission Control

    RE593951

    Fits various 7R, 8R, and 9R series tractors

Get help to fix this fault by requesting a quote

Browse other John Deere codes