John Deere 000629.06: High Amp Draw On Gear Solenoids

The system detects a high amp draw on gear solenoids, causing the module to overheat and shut down. The module will reset after one minute. This issue is associated with the Range Module Direct Drive (PL3).

1. 1

   Gear solenoids

2. 2

   Range Module Direct Drive (PL3)

3. 3

   Electrical connections to gear solenoids

4. 4

   Module temperature

1. 1

   Inspect

   Check the gear solenoids for signs of damage, wear, or excessive resistance.

2. 2

   Test

   Measure the current draw of the gear solenoids to confirm if it exceeds the expected range.

3. 3

   Inspect

   Examine the Range Module Direct Drive (PL3) for overheating, damage, or signs of electrical stress.

4. 4

   Check

   Verify all electrical connections to the gear solenoids and the Range Module Direct Drive (PL3) for looseness or corrosion.