000630.02

John Deere 000630.02 – BLC: User Settings Reset to Default

Issue description

The system has detected an internal fault related to the software configuration of the Cab Roof Module (Basic Light Control unit). This indicates that the main control unit user settings have been reset to their default values, meaning operator-programmed settings, such as custom lighting configurations, have been wiped or corrupted. No specific hardware component failure is initially identified.

Applies to these machines

  • 5620
  • 5720
  • 5820
  • 6100J
  • 6110J
  • 6125J
  • 6130J
  • 6145J
  • 6165J
  • 6180J
  • 6020
  • 6120
  • 6220
  • 6320
  • 6420
  • 6520
  • 6620
  • 6920
  • 6120L
  • 6220L
  • 6320L
  • 6420L
  • 6520L
  • 6415
  • 6615
  • 6715
  • 7515
  • 6215
  • 6420S

Check the cause

  1. Access and document all active and stored Diagnostic Trouble Codes (DTCs) using the onboard display before clearing any

  2. Clear the BLC 000630.2 fault code from the system

  3. Perform a functional check by operating the tractor and its lighting functions to determine if the fault is active or intermittent

  4. Review user-programmable settings in the CommandCenter display, particularly lighting configurations, to see if custom settings were lost

Repair steps

  1. Access onboard diagnostics

    Enter diagnostic mode through the tractor's display, typically using a combination of the turn signal lever and hazard light switch.

  2. Navigate to controller

    Cycle through the control units in the diagnostic menu until you locate the BLC or BCU.

  3. Clear codes

    Follow the display prompts to clear the active and stored fault codes.

  4. Reconfigure user settings

    Navigate to the lighting setup page on the CommandCenter display. Reconfigure desired floodlight and road light settings for different operating modes, then save the new configurations.

  5. Cycle power and verify

    Turn the tractor off and then back on to ensure the settings are saved and the fault code does not return.

  6. Reprogram software

    If the fault persists, have a certified technician reprogram the BLC/BCU using Service ADVISOR software to ensure uncorrupted software is installed. Over-the-air reprogramming may be possible for newer models with a Generation 4 display.

  7. Replace control module

    If reprogramming fails, the Basic Control Unit is likely faulty and requires replacement.

Parts you might need

(1)
  • Compatible with various 5000, 6000, and 7000 series tractors. May require dealer programming upon installation.

Get help to fix this fault by requesting a quote

Browse other John Deere codes