000653.18

John Deere 000653.18 – ECU: Fuel Injector #3 Flow Very Low

Issue description

The Engine Control Unit (ECU) has detected that the fuel flow to the number 3 injector is below the expected threshold or that the injector is not responding as commanded. This signifies a discrepancy in the operation or signal of the third fuel injector, meaning it is not delivering the correct amount of fuel to the cylinder due to an underlying mechanical or electrical issue.

Applies to these machines

  • 9470RT
  • 9520RT
  • 9570RT
  • 8310RT (for serial numbers 902501-912000)
  • 8335RT (for serial numbers 902501-912000)
  • 8360RT (for serial numbers 902501-912000)
  • 6090MC
  • 6090RC
  • 6100MC
  • 6100RC
  • 6110MC
  • 6110RC
  • Equipment with 9.0L (6090HF485) Tier 3 engines

Check the cause

  1. Visually inspect the wiring harness and connectors associated with injector number 3 for signs of damage, corrosion, or loose connections

  2. Check for other active fault codes that may indicate a broader fuel supply or general electrical issue

  3. Check fuel system basics, including fuel level and the condition of fuel filters, as clogged filters can cause low fuel pressure and trigger injector codes

  4. Perform a thorough inspection of the injector wiring harness, both internal to the valve cover and the main engine harness

  5. Perform an injector swap test by swapping the number 3 injector with an injector from another cylinder. If the fault code follows the injector to the new cylinder, the injector is faulty. If it remains on cylinder 3, the issue is likely wiring or the ECU

  6. Check the ECU for internal faults (typically the last step after all other possibilities have been exhausted)

Repair steps

  1. Address immediate issues

    If initial diagnostic checks reveal obvious problems such as damaged wiring or clogged fuel filters, rectify these issues first.

  2. Replace fuel injector

    If the swap test confirms the injector is faulty, remove the valve cover, disconnect the fuel line and electrical connector, remove the hold-down, and extract the injector. Install the new injector with new seals and torque to manufacturer specifications.

  3. Repair or replace wiring harness

    If the wiring harness is found to be faulty during inspection (and the fault did not follow the injector during the swap test), repair or replace the internal valve cover harness or the main engine harness as needed.

  4. Replace Engine Control Unit (ECU)

    If the ECU is determined to be the root cause after exhausting all other diagnostics, replace it and have it programmed by a qualified technician.

  5. Calibrate new injector

    After replacing an injector, calibrate it to the ECU using John Deere Service ADVISOR or a compatible aftermarket diagnostic tool.

Parts you might need

(3)
  • Potential part number; verify with serial number. Alternatives include SE501947 (Reman), RE557023, RE52109, or Denso 095000-6490.

  • Fuel Injector Line

    RE518595

    High-pressure fuel line for No. 3 injector. Replace if leaking or damaged.

  • Injector Wiring Harness

    Internal valve cover harness or main engine harness.

Get help to fix this fault by requesting a quote

Browse other John Deere codes