John Deere 000084.02 – BCU: Wheel Speed Sensor Signal Erratic
Issue description
The control unit is receiving an erratic, intermittent, incorrect, or out-of-range signal from the wheel speed sensor (SPN 84, FMI 2). This loss of plausible wheel-based vehicle speed data can negatively affect various machine functions that rely on accurate speed information, including transmission shifting, auto-steer, and precision farming applications.
Applies to these machines
25 machines- 5225
- 5325
- 5425
- 5625
- 6165J
- 6185J
- 6205J
- 6210J
- 8130
- 8230
- 8260R
- 8295R
- 8320R
- 8330
- 8345R
- 8360R
- 8430
- 8530
- 6M Series
- 6R Series
- 7M Series
- 8RT Series
- 8RX Series
- 6B Series
- 6E Series
Check the cause
Visually inspect the wheel speed sensor and its wiring harness for physical damage, cracks, chafing, or rubbing against moving components.
Check the sensor connectors for corrosion, damage, or loose pins.
Inspect the tone ring (phonic wheel/exciter ring) for damage, debris, or missing teeth.
Check wheel end components for loose wheel bearings or excessive hub runout, which can alter the critical gap between the sensor and the tone ring.
Test wiring harness continuity between the sensor connector and the ECU connector (resistance should be less than 5 ohms).
Check the wiring harness for shorts to ground (resistance should be greater than 100k ohms).
For passive (two-wire) sensors: Test AC voltage output by spinning the wheel at approximately half a revolution per second (expect a minimum of 0.2 to 0.25 volts AC).
For active (three-wire Hall-effect) sensors: Check for reference voltage at the connector with the key on, and observe the signal using an oscilloscope or capable scan tool.
Repair steps
Confirm the Fault
After performing diagnostics, if the sensor is identified as the faulty component, proceed with replacement.
Acquire the Correct Part
Obtain the correct OEM replacement wheel speed sensor based on the tractor's model and serial number.
Remove the old sensor
Safely raise and support the vehicle. Disconnect the sensor's electrical connector, remove any retaining bolts or clips, and pull the old sensor out of its mounting hole at the wheel hub.
Install the new sensor
Clean the sensor mounting surface thoroughly. Insert the new sensor and ensure it is properly seated. Set the critical gap between the sensor and the tone ring (for some designs, this involves pushing the sensor in until it makes light contact with the tone ring). Secure with retaining hardware.
Reconnect and secure wiring
Reconnect the electrical connector and ensure the wiring is properly routed and secured away from any moving parts or sources of heat.
Calibrate the sensor
If required by the specific John Deere model, perform a wheel speed sensor calibration. This typically involves driving a measured distance (e.g., 122 meters or 400 feet) and entering the values into the machine's display.
Clear codes and test
Clear the fault code from the control unit's memory. Operate the vehicle and use a diagnostic tool to verify that the wheel speed signal is present and accurate, and that the fault code does not return.
Parts you might need
(4)- Wheel Speed Sensor (Hall Effect)RE295929
Fits models including 5225, 5325, 8130, 8230, 8260R, 8295R, 8330, and 8430. Verify by serial number.
Fits various 6M, 6R, 7M, and 8R series tractors. Verify by serial number.
Fits various 6B, 6E, and 8R series tractors. Verify by serial number.
Fits a broad range of 6M, 6R, 7M, and 8R/8RT/8RX series tractors. Verify by serial number.
Get help to fix this fault by requesting a quote