John Deere 000084.14 – SCC: Wheel Speed Sensor Missing on CAN Bus
Issue description
The Rear Chassis Module (SCC) has detected that it is not receiving a signal from the wheel speed sensor via the CAN bus. This indicates that the sensor is disconnected, has failed, or there is a problem with the wiring or connectors between the sensor and the SCC module. The loss of this signal can negatively affect the proper operation of the vehicle's speed-related systems, including the transmission, traction control, and implement control systems.
Applies to these machines
8 machines- 6110R
- 6120R
- 6130R
- 6145R
- 6155R
- 6175R
- 6195R
- 6215R
Check the cause
Cycle the ignition by turning the tractor off, waiting a few moments, and restarting to see if the code clears.
Visually inspect the wiring harness and connectors between the wheel speed sensor and the SCC module for chafing, corrosion, or loose connections.
With vehicle power OFF, measure resistance between CAN High and CAN Low wires at a diagnostic or module connector. It should be approximately 60 Ohms (120 Ohms suggests a missing/disconnected resistor; significantly lower suggests a short circuit or extra resistor).
With vehicle power ON, measure CAN bus voltages relative to chassis ground. CAN High should be 2.5-3.0V, CAN Low should be 2.0-2.5V. Abnormal voltages indicate a short to power, short to ground, or faulty control module.
Check for correct voltage supply and a good ground connection at the wheel speed sensor connector.
Check if the wheel speed sensor requires calibration, which typically involves driving the vehicle over a measured distance.
Repair steps
Park machine safely
Lower all implements, shut down the engine, and remove the key.
Locate the wheel speed sensor
The sensor is typically located on or near the rear axle housing, positioned to read a tone ring.
Disconnect the electrical connector
Carefully release the locking tab and unplug the wiring harness from the sensor.
Remove the sensor
Remove the retaining fasteners and carefully pull the sensor out of its mounting bore. It may be necessary to gently twist the sensor to break it free.
Install the new sensor
Clean the mounting surface. Set the specific air gap if required (e.g., install until it lightly touches the tone ring and then back out a specified amount). Tighten the retaining bolt(s) to the manufacturer's specified torque and securely reconnect the electrical connector.
Clear fault codes and test
After installation, clear any active fault codes and operate the vehicle to ensure the code does not return. A calibration may be necessary.
Prepare for SCC module replacement (if applicable)
If diagnostics point to a faulty SCC module, park the machine safely and disconnect the battery.
Locate the SCC module
The SCC module is often found within the tractor's cab or on the chassis.
Disconnect SCC electrical connectors
Carefully release the locking mechanisms and disconnect the large multi-pin connectors from the module.
Remove the SCC module
Unbolt the module from its mounting bracket.
Install the new SCC module
Mount the new SCC module and securely reconnect all electrical connectors.
Reconnect the battery
Reconnect the vehicle's battery.
Program/Configure the SCC module
Have a John Deere dealer program or configure the new control module to ensure it communicates correctly with the other control units on the vehicle.
Parts you might need
(4)- Wheel Speed Sensor (36mm)RE330846
OEM part compatible with 6R series
OEM part compatible with 6R series
Wheel Speed Sensor
AUC12197Aftermarket cross-reference
OEM Rear Chassis/SCV Control Module
Get help to fix this fault by requesting a quote