000876.01

John Deere 000876.01 – ATC / ETC: M02 Compressor Clutch, Power Supply Fault at Power Module (HF) PC6

Issue description

The PC6 Power Module detects a supply voltage of less than 3 volts at the A/C compressor clutch output (lead 0732) when the compressor clutch (M02) is commanded on. This low voltage condition indicates a power supply fault in the circuit, which prevents the compressor clutch from engaging and disables the air conditioning. The root cause is typically a poor electrical connection, insufficient source voltage reaching the module, a short or draw in the clutch coil, or an internal failure of the power module itself.

Applies to these machines

  • 6230 Premium
  • 6330 Premium
  • 6430 Premium
  • 7130 Premium
  • 7230 Premium
  • 7330 Premium
  • 7430 Premium
  • 7530 Premium

Check the cause

  1. Verify the fuses supplying source voltage to the PC6 Power Module (commonly F05/12 or F07/12 depending on the model) are intact and not blown

  2. Measure the voltage at the compressor clutch output (lead 0732) when the A/C is switched on; it must be consistently above 3 volts

  3. Examine lead 0732 and the compressor clutch connectors for signs of corrosion, loose pins, or wire chafing

  4. Unplug the compressor clutch and apply direct 12V power to it briefly to see if the clutch engages

  5. Measure the resistance of the clutch coil to ensure it is not shorted, which could pull the circuit voltage down

  6. Verify that the source voltage feeding into the PC6 power module is adequate and stable (12V+)

  7. Inspect the ISOBUS socket at the rear of the tractor, as a faulty CAN terminator can sometimes cause communication anomalies with the PC6 module

Repair steps

  1. Repair wiring

    If any damage, corrosion, or loose connections were found on lead 0732 between the PC6 module and the compressor clutch, repair or replace the compromised wiring and ensure it is properly insulated.

  2. Replace compressor clutch

    If the direct 12V test failed to engage the clutch, or if the clutch coil is shorted/defective and dragging down the circuit voltage, replace the M02 compressor clutch assembly.

  3. Replace PC6 power module

    If the wiring is good, the clutch operates normally under direct power, and the PC6 module is receiving good source voltage but still outputting less than 3 volts on lead 0732, the PC6 power module has failed internally and must be replaced.

  4. Perform system test

    After repairs, clear the fault codes and run the tractor. Turn on the A/C to verify the compressor clutch engages properly and the 000876.01 code does not return.

Parts you might need

(2)

Get help to fix this fault by requesting a quote

Browse other John Deere codes