John Deere C00: Controller Failed EEPROM Test at Power-Up

The controller has failed an EEPROM test during power-up. This indicates a potential issue with the memory or internal circuitry of the controller. The system recommends replacing the Armrest Control Unit if the condition persists.

1. 1

   Controller

2. 2

   Armrest Control Unit

1. 1

   Verify the fault code

   Confirm that the fault code C00 is still present after restarting the system.

2. 2

   Inspect the Armrest Control Unit

   Check the Armrest Control Unit for visible damage or connection issues.

3. 3

   Replace the Armrest Control Unit

   If the fault persists, replace the Armrest Control Unit as recommended.