CAB523667

John Deere CAB523667 – CAB: Chassis Tilt Indicator Short to Power

Issue description

The Cab Control Unit (CAB) has detected an unexpected voltage on the circuit for the Chassis Tilt Engaged Indicator (cc# 535). The controller has commanded the indicator light's driver circuit to be in a low state (OFF), but it is detecting voltage. This indicates an abnormal electrical condition, typically a short circuit to a power source, a faulty indicator light assembly, or an internal failure within the CAB controller itself.

Applies to these machines

  • 9570 STS
  • 9670 STS
  • 9770 STS
  • 9870 STS

Check the cause

  1. Visually inspect the wiring harness leading to the chassis tilt indicator for any signs of damage, chafing, melting, or corrosion.

  2. Using a digital multimeter, check for voltage on the signal wire of the Chassis Tilt Engaged Indicator (cc# 535) when the key is on but the indicator should be off (presence of voltage confirms a short to power).

  3. Disconnect the Chassis Tilt Engaged Indicator from the wiring harness to isolate the component; if the fault code disappears, the indicator itself is faulty.

  4. Check the wiring for continuity to ground and for shorts between wires.

  5. Review the operator's manual for specific key switch cycling sequences that may clear the diagnostic trouble code.

Repair steps

  1. Repair wiring harness

    If the visual inspection or multimeter tests reveal damaged wiring or a short to power, repair or replace the affected section of the harness.

  2. Replace indicator assembly

    If disconnecting the Chassis Tilt Engaged Indicator clears the fault, replace the indicator component. Note that it may be integrated into a larger dashboard assembly or console.

  3. Replace CAB controller

    If both the wiring and the indicator are confirmed to be in good condition, replace the Cab Control Unit (CAB). Ensure the replacement part number exactly matches the existing unit.

  4. Clear codes and verify

    After any repair is completed, clear all fault codes and operate the machine to ensure the fault does not return.

Parts you might need

(5)
  • Chassis Tilt Engaged Indicator

    May be integrated into a larger dashboard assembly. Consult parts catalog (e.g., PC9661) for exact part number.

  • Cab Control Unit (CAB)

    AH230756

    Left Hand Vehicle Controller (LC1). Interchanges with AXE66868, AH222195. Match to existing unit.

  • Interchanges with AXE66869. Match to existing unit.

  • Electronic Control Unit compatible with 9870 STS. Match to existing unit.

  • Cab Control Unit (CAB) - Remanufactured

    RM100130

    Remanufactured option. Match to existing unit.

Get help to fix this fault by requesting a quote

Browse other John Deere codes