E04

John Deere E04 – LC2: Left Control Unit 2 Diagnostic

Issue description

The Left Control Unit 2 (LC2) has detected a diagnostic trouble code. This code represents a category of faults rather than a single specific issue, ranging from electrical problems to communication errors with other vehicle systems. The specific nature of the problem must be identified by retrieving the accompanying SPN and FMI codes from the diagnostic display.

Applies to these machines

  • 9560 STS
  • 9650 STS
  • 9660 STS
  • 9750 STS
  • 9760 STS
  • 9860 STS
  • 9470 STS
  • 9570 STS
  • 9670 STS
  • 9770 STS
  • 9870 STS
  • S540
  • S550

Check the cause

  1. Use the machine's diagnostic display to retrieve the full SPN and FMI code associated with the E04 alert to determine the specific fault.

  2. Check if other control units are logging diagnostic trouble codes, which could indicate a broader system issue like a CAN bus problem.

  3. Inspect the electrical connectors for the Left Control Unit 2 (labeled X314 and X315) for dirt, damage, or loose connections.

  4. Check the battery and charging system to ensure the battery is in good condition, the alternator is charging correctly, and the system voltage does not exceed 15.5 VDC (especially for voltage-related codes like E04 627.03).

Repair steps

  1. Resolve Boot Block Program Errors (E04 628.12)

    Disconnect the Left Control Unit 2 connectors (X314 and X315), wait a few moments, and securely reconnect them. If the condition persists, replace the Armrest Control Unit.

  2. Resolve EEPROM Failure (E04 630.11)

    Power cycle the machine. If the code persists after a power cycle, replace the Left Control Unit 2 due to internal memory failure.

  3. Resolve High Voltage Errors (E04 627.03)

    Investigate the vehicle's charging system for faults causing the voltage to exceed 15.5 VDC. This is a Priority 1 code indicating a serious issue.

  4. Resolve CAN Bus Communication Errors (E04 190.09, E04 1503.09)

    Inspect the CAN bus wiring harness for damage, shorts, or open circuits. Check the terminating resistors in the CAN bus circuit. Also, verify the transmitting controllers (e.g., Engine Control Unit or Armrest Control Unit) are functioning properly.

Parts you might need

(4)

Get help to fix this fault by requesting a quote

Browse other John Deere codes