4

Kubota 4 – Display: Service Due Notification

Issue description

This code is not a traditional fault indicating a component failure. It is a 'Service Due Notification' or 'Service Inspect' light triggered by the machine's internal hour meter. It serves as a pre-programmed maintenance reminder that a scheduled service interval has been reached and routine maintenance is required.

Applies to these machines

  • L-Series
  • L39
  • L3940
  • L4330
  • L5060
  • Grand L Series
  • L30 Series
  • M-Series
  • M7131
  • KX Series
  • KX91-3
  • KX161-3

Check the cause

  1. Acknowledge that the machine has reached a manufacturer-recommended service interval

  2. Consult the operator's manual to identify the specific scheduled maintenance required for the current hour meter reading

Repair steps

  1. Perform scheduled maintenance

    Complete the required routine maintenance such as changing oils and filters as outlined in the operator's manual.

  2. Reset L39 Tractors

    With the tractor running, press and hold two buttons on the dash simultaneously until you hear a beep, which will turn off the light.

  3. Reset Grand L Series (e.g., L3940)

    Turn the ignition key to the 'ON' position without starting the engine. Press and hold the 'display mode' button and the 'travel speed' button at the same time for approximately two seconds until the 'service inspect' light disappears.

  4. Reset L30 Series Tractors

    Navigate the display to show the engine hours. Then, press both buttons on the display at the same time until the indicator clears.

  5. Reset M7131 Tractors

    On the setting mode screen, use the 'Select' switch to highlight the maintenance item that has been serviced. Press the 'ENT' switch, choose 'YES' on the reset screen using the 'Select' switch, and then press 'ENT' again to reset the service hours to zero.

  6. Reset KX161-3 Excavators

    Turn the ignition key to the 'ON' position (engine off). Press and hold the mode or reset button on the display panel until the service indicator either blinks or turns off.

  7. Reset KX91-3 Mini-Excavators

    Turn the ignition key on and off 10 times to reset the service reminder.

Parts you might need

(7)
  • Engine oil filter

    OEM part numbers are specific to the machine's model and engine type and should be verified through an official parts catalog or dealer

  • Fuel filter

    OEM part numbers are specific to the machine's model and engine type and should be verified through an official parts catalog or dealer

  • Hydraulic oil filter

    OEM part numbers are specific to the machine's model and engine type and should be verified through an official parts catalog or dealer

  • Transmission filter

    OEM part numbers are specific to the machine's model and engine type and should be verified through an official parts catalog or dealer

  • Air filter

    OEM part numbers are specific to the machine's model and engine type and should be verified through an official parts catalog or dealer

  • Engine oil

    OEM part numbers are specific to the machine's model and engine type and should be verified through an official parts catalog or dealer

  • Hydraulic fluid

    OEM part numbers are specific to the machine's model and engine type and should be verified through an official parts catalog or dealer

Get help to fix this fault by requesting a quote

Browse other Kubota codes