Kubota E:014 – Meter Panel: Engine Oil Pressure Too Low
Issue description
The engine oil pressure has dropped below a safe specified level while the engine is running. The engine oil pressure switch is registering as 'ON' (closed circuit indicating low pressure) during engine operation, which triggers the master warning light and logs the fault code.
Applies to these machines
9 machines- KX018-4
- KX030-4
- KX057-4
- KX080-3
- U-17
- U17-3a
- U25-3S
- U35-4
- U50-5S
Check the cause
Stop the engine immediately to prevent the engine from seizing or requiring complete replacement.
Check the engine oil level using the dipstick. Ensure the oil is not heavily contaminated or degraded.
Access the meter panel's 'Tester Mode' via the LCD display settings to check the operation of the engine oil switch (the system will indicate if the circuit is Disconnected, Normal, or Shorted).
Inspect the wiring harness and electrical connector leading to the engine oil pressure switch for breaks, corrosion, or a short to ground.
Repair steps
Secure the machine
Park the excavator on level ground, turn off the engine, and attach a 'DO NOT OPERATE' tag to the controls.
Correct fluid levels
If the diagnostic check revealed low engine oil, top it off with Kubota-approved DPF-compatible engine oil (e.g., CJ-4) to the specified level. If the oil is due for a change, drain the oil and replace the genuine Kubota oil filter.
Replace the oil pressure switch
If the oil level is correct but the code persists, the oil pressure switch is likely faulty. Disconnect the electrical connector, use a wrench to unthread the old switch from the engine block, thread in the new OEM oil pressure switch, and reconnect the electrical harness.
Clear error history
Access the meter panel settings (SET-2 for recent error history or SET-5 for entire error history) and clear the stored E:014 code.
Verify repair
Start the engine. The engine oil pressure warning lamp should go out immediately after the engine starts, and the code should not return.
Parts you might need
(6)Engine Oil Pressure Switch
15841-39010- Engine Oil Pressure Switch15841-39013
- Engine Oil Pressure Switch15221-39013
- Engine Oil Pressure Switch1A024-39010
DPF-compatible engine oil (CJ-4)
Engine Oil Filter
Get help to fix this fault by requesting a quote