E-64

Kubota E-64 – GST Controller / Transmission ECU: Solenoid 4 failure

Issue description

The tractor will typically display a flashing "GST" light on the dash, and the transmission will fail to shift into specific gears or may refuse to go into any gear at all.

Applies to these machines

  • L3130
  • L3430
  • L3830
  • L4630
  • L5030
  • L3240
  • L3540
  • L3940
  • L4240
  • L4740
  • L5040
  • L5240
  • L5740

Check the cause

  1. Visually inspect the wiring harness and the specific connector going to Solenoid 4 on the GST valve block for severed wires or a shattered plastic connector (most common cause due to debris impact).

  2. If the wiring is intact, use a multimeter to check the resistance across the pins of Solenoid 4 to verify if the solenoid coil has internally shorted or opened (solenoid failure cause).

  3. Verify that the hydraulic fluid is at the proper level, as low fluid can cause secondary shifting issues.

Repair steps

  1. Disconnect battery

    For a broken connector/wiring: Disconnect the tractor's battery.

  2. Locate connector

    Locate the damaged GST solenoid connector on the transmission valve block.

  3. Prepare wiring

    Cut away the damaged connector and strip back the insulation on the factory harness to expose clean wire.

  4. Obtain repair kit

    Obtain the Kubota GST Solenoid Repair Lead Kit (pigtail).

  5. Splice wires

    Splice the color-coded wires of the new pigtail to the matching wires on the tractor's harness.

  6. Solder and seal

    Solder the connections and seal them thoroughly with marine-grade adhesive heat-shrink tubing to waterproof the repair.

  7. Test repair

    Plug the new connector into Solenoid 4, reconnect the battery, and test the tractor's shifting.

  8. Clean area

    For a failed solenoid: Clean the area around the GST valve block thoroughly to prevent dirt from entering the hydraulic system.

  9. Disconnect harness

    Disconnect the wiring harness from the faulty solenoid.

  10. Remove solenoid

    Unbolt and remove Solenoid 4 from the GST valve block.

  11. Install new solenoid

    Install the new solenoid, torque to OEM specifications, and reconnect the wiring harness.

Parts you might need

(3)
  • ASSY WIRE HARNESS, GST SOLENOID

    TD060-99110
  • GST Valve Assembly

    TA040-99034

Get help to fix this fault by requesting a quote

Browse other Kubota codes