Kubota E:9004 – Engine ECU: Requirement for DPF replacement
Issue description
The Diesel Particulate Filter (DPF) has reached its maximum allowable soot/ash accumulation limit, or the regeneration system has been overloaded to the point where a standard or forced regeneration is no longer possible. The machine will typically enter a severe limp mode (engine output and acceleration limited) to protect the engine.
Applies to these machines
7 machines- SVL65-2
- SVL75-2
- SVL90-2
- SVL95-2s
- SVL97-2
- SSV65
- SSV75
Check the cause
Check the DPF inhibit switch to ensure it was not accidentally left engaged, which prevents routine self-cleaning cycles (if E:9006 is also present, the inhibit switch is the primary culprit).
Check the DPF Differential Pressure Sensor and its rubber piping (front and back) for cracks, melting, or blockages, as a failed sensor can trick the ECU into thinking the DPF is completely plugged.
Verify the Thermo 0, Thermo 1, and Thermo 2 (T2) exhaust temperature sensors are reading correctly. A failed T2 sensor will prevent active regeneration.
Connect the Kubota Diagmaster software to read the exact soot/ash load percentages and confirm the filter substrate is actually at the end of its life.
Repair steps
Preparation
Move the machine to a safe, level area. Disconnect the battery (negative/ground cable first).
Sensor Removal
Carefully disconnect the wiring harnesses for the DPF exhaust temperature sensors and the NOx sensors.
Piping Removal
Disconnect the DPF differential pressure sensor rubber piping from the front and back of the DPF housing.
DPF Extraction
Unbolt the clamps and mounting hardware securing the DPF muffler assembly to the exhaust system and remove the DPF.
Installation
Install the new or remanufactured DPF assembly. Reconnect all mounting hardware, temperature sensors, and pressure piping.
ECU Reset
You must use the Kubota Diagmaster software to reset the DPF ash accumulation data in the Engine ECU. If you do not reset this data, the ECU will still think the filter is clogged and the E:9004 code will remain active.
Parts you might need
(4)SVL75-2 DPF Assembly (OEM Direct Fit)
1E726-18251- SVL95-2s / SVL97-2 DPF Filter Kit (New)1J508-18930
- DPF Exhaust Temperature Sensor (Thermo 2)1J500-18522
Get help to fix this fault by requesting a quote