E:9108

Kubota E:9108 – Engine ECU: Battery voltage system

Issue description

The machine's control system has detected an abnormal voltage condition, such as low battery voltage, an overcharge condition, or a failure in the charging system. The engine may be stopped automatically, or the engine RPM and output will be limited.

Applies to these machines

  • SSV65
  • SSV75
  • SVL65-2
  • SVL75
  • SVL75-2
  • SVL75-3
  • SVL90
  • SVL90-2
  • SVL95-2s
  • SVL97-2
  • SVL97-3
  • R430

Check the cause

  1. Battery Test: Check the resting voltage of the battery (should be around 12.6V). Perform a load test to ensure the battery can hold a charge.

  2. Charging System Test: Start the engine and measure the voltage at the battery terminals. It should read between 13.5V and 14.5V. If it does not increase from the resting voltage, the alternator is likely failing.

  3. Terminal & Cable Inspection: Inspect the battery terminals and cables for heavy corrosion, looseness, or fraying.

  4. Fuse & Relay Check: Inspect the main electrical panel. Check the Engine ECU fuses (typically 5A), the main bolted fuse (typically 60A), and the main relay.

  5. Wiring Harness: Inspect the wiring harness connecting the alternator, battery, and Engine ECU for breaks, chafing, or short circuits.

Repair steps

  1. Safety First

    Turn off the machine, remove the key, and allow the engine to cool.

  2. Disconnect the Battery

    To avoid short-circuiting the system, always remove the ground (negative) cable first, followed by the positive cable.

  3. Clean and Tighten

    Clean the battery posts and cable terminals with a wire brush. Reconnect the cables (positive first, then negative) and ensure they are tight.

  4. Replace the Battery (if faulty)

    If the battery failed the load test, remove the battery hold-down bracket and replace the battery with a new Group 31A unit.

  5. Replace the Alternator (if faulty)

    If the alternator is not charging the battery, disconnect the electrical connectors on the rear of the alternator. Relieve the tension on the serpentine belt, remove the alternator mounting bolts, and install the replacement unit. Re-tension the belt to OEM specifications.

  6. Clear Codes

    Turn the key to the ON position. If the voltage issue is resolved, the Engine ECU should recognize the correct voltage. Cycle the machine to ensure the E:9108 code clears from the advanced display monitor and does not return under load.

Parts you might need

(7)
  • Battery (Group 31A, 950 CCA)

    KB31A-00453
  • Battery (Group 31A, 950 CCA)

    77700-00453
  • Alternator (12V, 80A)

    1J755-64010
  • Positive Battery Cable

    V0521-55242

Get help to fix this fault by requesting a quote

Browse other Kubota codes