E:9302

Kubota E:9302 – Engine ECU: Engine fuel system (air in the fuel system) or Engine fuel system (leakage)

Issue description

The system detects low fuel pressure, which is typically caused by a restriction in the fuel supply before the common rail fuel pump, or by air being sucked into the fuel lines. The machine will usually go into limp mode to protect the engine.

Applies to these machines

  • SVL95-2s
  • SVL97-2
  • SVL75-2
  • SVL65-2
  • SSV65
  • SSV75

Check the cause

  1. Check the fuel level, as operating on a low tank (especially on uneven ground) can cause fuel sloshing and introduce air into the intake lines.

  2. Inspect the primary fuel filter to see if it is heavily clogged with dirt or gelled fuel.

  3. Check the fuel/water separator bowl for water, algae, or debris.

  4. Inspect the fuel tank sump for debris by removing the LH rear cleanout plate, unplugging the drain hose, and draining fuel into a catch can to check for heavy contamination or water.

  5. Inspect the supply hoses from the tank inlet to the electrical pump and injection pump for clogs, kinks, or loose fittings that could draw in air.

Repair steps

  1. Drain Contaminants

    If water or heavy debris was found during the sump check, completely drain and flush the fuel tank.

  2. Replace Filters

    Remove and replace both the main fuel filter and the water separator filter element.

  3. Refill the Tank

    Fill the tank with fresh, clean diesel fuel.

  4. Bleed the Fuel System

    Follow the operator's manual procedure to bleed the air out of the fuel system.

  5. Clear the Code

    Turn the machine off and back on. If the machine remains in limp mode and the code persists, a dealer may need to connect the Kubota Diagmaster software to the ECU to manually clear the stored DTCs.

Parts you might need

(2)
  • Fuel Filter1K94743172
  • Water Separator Filter Element

Get help to fix this fault by requesting a quote

Browse other Kubota codes