E:9303

Kubota E:9303 – Engine ECU (Engine Control Unit): Engine fuel system (SCV) malfunction

Issue description

Indicates a malfunction in the Engine fuel system (SCV). The Suction Control Valve (SCV) regulates the volume of fuel entering the pumping chambers to control common rail fuel pressure. When active, engine output is severely limited (derated), and the machine may fail to move or stall under load.

Applies to these machines

  • SSV65
  • SSV75
  • SVL65-2
  • SVL75
  • SVL75-2
  • SVL90-2
  • SVL95-2s
  • SVL97-2
  • R430
  • R530
  • R540
  • R630
  • R640
  • KX040-4
  • KX057-4
  • KX080-4
  • M6060
  • M7060
  • M100GX
  • L3301
  • L3901
  • L4060

Check the cause

  1. Check fuel level and ensure you are using Ultra Low Sulfur Diesel.

  2. Inspect the fuel filter for clogs and check if the water separator is full (a restricted fuel filter is the most common external cause).

  3. Inspect the electrical harness connector at the SCV for loose connections or damage caused by debris.

  4. Use Kubota Diagmaster software (if available) to monitor SCV current (mA) and check for a stuck control rack or failing lift pump.

Repair steps

  1. Clean the Area

    Thoroughly clean the engine compartment around the high-pressure fuel pump. Avoid any contamination to the fuel high-pressure pump during removal. Failure to maintain a high level of cleanliness will cause further damage to the fuel system components.

  2. Disconnect Battery

    Disconnect the negative battery cable to prevent short circuits.

  3. Disconnect Wiring

    Unplug the electrical harness connector from the SCV on the supply pump.

  4. Remove the SCV

    Remove the two mounting bolts securing the SCV to the high-pressure supply pump and pull the valve out.

  5. Prep the New Valve

    Lubricate the new O-ring and install it on the new SCV. Fill the new SCV with clean diesel fuel prior to installation.

  6. Install the New SCV

    Insert the new SCV into the supply pump and tighten the two mounting bolts.

  7. Reassemble and Bleed

    Reconnect the electrical harness, reconnect the battery, and bleed the fuel system to remove air before starting the engine.

Parts you might need

(3)

Get help to fix this fault by requesting a quote

Browse other Kubota codes