E-99

Kubota E-99 – Instrument Panel / Dash Cluster: Communication trouble

Issue description

Indicates a failure in the CAN bus network communication between the tractor's instrument panel (dash cluster) and the onboard electronic control units (ECUs).

Applies to these machines

  • M5660SUH
  • M5660SUHD
  • M6060
  • M7060
  • M8560
  • M9960
  • M7001 Series
  • M7131
  • M7151
  • M7171

Check the cause

  1. Check the 5-amp fuse for the dash panel cluster, as a blown fuse is the most common cause.

  2. Identify the sub-code on the dash (e.g., 'Eng NG' or 'ECU NG') to isolate which module is failing to communicate.

  3. Inspect the CAN bus wiring between the instrument panel and the ECUs for chafing, cuts, or shorts to ground.

  4. Connect a Kubota Diagnostic Tool (KTM or dealer-level software) to read the full error logs and isolate the specific sensor or circuit failure if the fuse is intact.

Repair steps

  1. Locate the Fuse Box

    Access the tractor's fuse box and locate the 5-amp fuse designated for the instrument panel/dash cluster.

  2. Replace the Fuse

    If blown, replace it with a new 5-amp fuse. Turn the key to the ON position to see if the ERROR-99 code clears.

  3. Trace for Shorts

    If the new fuse immediately blows, you have a short to ground. Remove the cowl panel to access the rear of the instrument cluster. Trace the wiring harness from the dash down to the ECUs, looking for pinched wires near the steering column or battery box. Repair any damaged wires.

  4. Inspect Connectors

    Disconnect the wiring harnesses at the Instrument Panel, the Engine ECU, and the Tractor ECU. Inspect the pins for corrosion, moisture, or pushed-out terminals. Clean with contact cleaner and reconnect.

  5. Module Replacement

    If the wiring is perfectly intact, the CAN bus terminating resistors test fine, and the fuse is good, the fault lies internally within either the Instrument Panel or the ECU. These modules must be replaced and reprogrammed by an authorized Kubota dealer.

Parts you might need

(6)
  • 5-Amp Fuse

  • Instrument Cluster / Performance Monitor

  • Engine ECU1H026-59093
  • Engine ECU

    1J779-59051
  • Engine ECU3C131-75402

Get help to fix this fault by requesting a quote

Browse other Kubota codes