P0101

Kubota P0101 – Engine ECU (Engine Control Unit): Intake Air Volume: Low

Issue description

The engine inlet air mass flow rate is lacking or measuring at less than half of the target value expected by the engine. When this code is triggered, the machine will typically enter a limp-home mode to protect the engine, which limits engine output to approximately 75% of normal conditions, stops the EGR valve function, and forces the intake throttle 100% open.

Applies to these machines

  • D1803-CR
  • V1505
  • V2403-CR
  • V2607-CR
  • V3307-CR
  • V3800-CR
  • L3301
  • L4701
  • L5460
  • L6060
  • MX5200
  • M5660SU
  • M7060
  • SSV65
  • SSV75
  • SVL65-2
  • SVL75-2
  • SVL90-2
  • SVL95-2S
  • SVL97-2
  • KX040-4
  • KX057-4
  • KX080-4
  • U48-5
  • U55-4

Check the cause

  1. Check the primary and secondary air filters for heavy dirt restriction, accidentally left plastic wrapping, or use of non-genuine filters.

  2. Inspect the air box for physical blockages (e.g., rodent nests or debris) and check all intake and turbo blower hoses for disconnections, leaks, or loose clamps.

  3. Inspect the MAF sensor connector and wiring harness for proper pin fit and tension on the female connector terminals.

  4. With the key switch in the ON position, measure the voltage between MAF sensor terminals 1 and 2 (should be approximately 10 to 16 V).

  5. Remove the MAF sensor and inspect it for dirt, dust, or an oily film.

Repair steps

  1. Clear Intake Restrictions

    Replace dirty air filters and clear any debris from the air box. Tighten any loose hose clamps on the intake and turbocharger hoses.

  2. Clean the MAF Sensor

    Disconnect the wiring harness and remove the MAF sensor from the air intake snorkel. Using a dedicated Mass Air Flow Sensor Cleaner (DO NOT substitute with brake cleaner, carb cleaner, or any other solvent), spray each side of the sensor for 3-5 seconds. Wait 10 seconds, then spray again for 3-5 seconds. Do not wipe or touch the sensitive hot wires. Allow it to dry completely.

  3. Reinstall and Test

    Reinstall the MAF sensor, reconnect the harness, and run the machine up to normal operating temperature.

  4. Replace the MAF Sensor

    If the P0101 code returns immediately after the engine warms up and all wiring/intake checks pass, the sensor itself has failed internally and must be replaced.

  5. Clear the Code

    Disconnect the negative battery cable for 20 minutes to attempt a computer reset. If the code persists as a hard code in the ECU, a dealer utilizing Kubota's proprietary Diagmaster software laptop will be required to clear it.

Parts you might need

(5)
  • Mass Air Flow (MAF) Sensor

    1J520-10701
  • Mass Air Flow (MAF) Sensor

    AFH70M-106
  • Air Filter Elements (Primary & Secondary)

  • Mass Air Flow Sensor Cleaner

Get help to fix this fault by requesting a quote

Browse other Kubota codes