P0103

Kubota P0103 – Engine ECU: MAF Sensor Abnormality (High side)

Issue description

The system detects a +B (battery voltage) short circuit in the Mass Air Flow (MAF) sensor or its wiring harness, or an internal failure of the sensor itself. When this code is active, the engine will experience insufficient output (derate) and worsening exhaust gas performance.

Applies to these machines

  • V1803
  • V2403
  • V2607
  • V3307
  • V3800
  • SSV65
  • SSV75
  • SVL65-2
  • SVL75-2
  • SVL90-2
  • SVL95-2S
  • SVL97-2
  • KX040-4
  • KX057-4
  • KX080-4
  • U48-5
  • U55-4
  • L5060

Check the cause

  1. Verify preconditions: The ECU sets this code when battery voltage is normal, engine speed is between 700 and 2800 RPM, and the target intake mass air flow is 460 or less for 3 continuous seconds.

  2. Inspect the wiring harness leading to the MAF sensor for chafing, melted insulation, or pinched wires that could cause a short circuit to battery voltage (+B).

  3. Disconnect the sensor and turn the key ON. Measure the sensor supply voltage at the connector to ensure it is within normal operating range and not shorted to a high-voltage source.

Repair steps

  1. Power Down

    Turn off the engine and remove the key from the ignition.

  2. Locate the Sensor

    Locate the MAF sensor, which is mounted on the engine's air intake assembly (post-air filter).

  3. Disconnect

    Unplug the 5-pin electrical connector from the MAF sensor.

  4. Test the Harness

    Using a multimeter, probe the harness side of the connector to confirm there is no short to battery voltage on the signal wire. If a short is found, trace the harness back to the ECU and repair the damaged wiring.

  5. Replace the Sensor

    If the harness tests good, the MAF sensor has failed internally. Remove the mounting screws securing the sensor to the intake housing.

  6. Install New Part

    Insert the new OEM MAF sensor, secure the screws, and plug in the 5-pin connector.

  7. Clear Codes

    Use Kubota Diagmaster (or a compatible diagnostic scan tool) to clear the P0103 fault code. Run the engine to verify that normal output is restored and the code does not return.

Parts you might need

(3)
  • Mass Air Flow (MAF) Sensor

    1J520-10701
  • Mass Air Flow (MAF) Sensor

    AFH70M-106

Get help to fix this fault by requesting a quote

Browse other Kubota codes