Kubota P0204 – ECM: Injector Circuit Open - Cylinder 4
Issue description
A fault has been detected in the affected circuit, indicating an open circuit condition. This diagnostic trouble code (DTC) is logged when the Engine Control Module (ECM) detects a voltage or resistance value outside the expected range for the cylinder 4 fuel injector circuit. This points to a break or high-resistance issue in the wiring or components, which may result in improper operation, engine misfire, rough idle, reduced power, increased fuel consumption, or the engine entering limp mode.
Applies to these machines
9 machines- MX4800
- SVL95-2s
- SVL75
- SVL75-2
- SSV75
- KX080-4
- SVL97-2
- M5-091
- M5-111
Check the cause
Verify the fault code using a diagnostic scan tool and check for accompanying codes, such as a misfire code for cylinder 4 (P0304)
Visually inspect the wiring harness and electrical connector for the cylinder 4 fuel injector for chafed or broken wires, corrosion, or loose connections
Check for battery voltage (typically 12 volts on one wire) at the fuel injector's electrical connector with the key in the 'on' position using a multimeter
Disconnect the fuel injector and measure the resistance across its two electrical terminals, comparing the reading to manufacturer specifications or a known good injector
Plug a noid light into the injector connector and crank the engine to verify the ECM is sending the control pulse (light should flash)
If the noid light test fails, perform a continuity test on the control wire between the injector connector and the ECM connector to check for an open circuit or short to ground
Repair steps
Repair wiring and connectors
If the visual inspection reveals any damaged wiring or a corroded connector, repair or replace the affected parts. Ensure the connector is clean and makes a secure connection.
Replace the fuel injector
If diagnostic checks (such as incorrect resistance) point to a faulty fuel injector, replace it. Note that a new calibration code may need to be programmed into the ECM after installation.
Address ECM issues
If all wiring and the injector itself test good, the issue may lie with the injector driver circuit within the ECM. This typically requires professional diagnosis and potentially ECM repair or replacement.
Clear codes and verify repair
After performing the repair, clear the fault codes using a scan tool and operate the machine to ensure the code does not return.
Parts you might need
(3)- Fuel Injector (Cylinder 4)1J770-53074
Denso 295050-1980. Fits V3307-CR-TE4 engines (SVL75/SVL75-2, SSV75, KX080-4).
Fuel Injector (Cylinder 4)
1J508-53076Fits V3800-TIEF4 engines (SVL95-2S, SVL97-2, M5-091, M5-111).
- Fuel Injector (Cylinder 4)1G410-53050
Denso 095000-7510. Fits V6108-TI-CRS engines.
Get help to fix this fault by requesting a quote