P0380

Kubota P0380 – Engine ECU: Air Heater (Glow) Relay Driving Circuit Abnormality

Issue description

This code indicates a malfunction in the control circuit for the air heater (glow plug) relay. The Engine ECU has detected a +B (battery voltage) short circuit, a ground short, or an open circuit in the relay driving circuit. The abnormality is triggered when the battery voltage is normal and the air heater relay drive command is activated for 1 second or more.

Applies to these machines

  • M108X
  • L3010
  • L3240
  • L3560
  • L3800
  • L3901
  • L4400
  • L4760
  • L5040
  • L6060
  • B2320
  • B2410
  • B2650
  • V3800-CR-TE4
  • V3800-CR-TIE4
  • V6108-TIE3
  • V2403-CR-TE4B

Check the cause

  1. Verify the battery is fully charged and holding proper voltage, as a weak or drained battery during cranking can trigger this code

  2. Verify ambient and coolant temperatures; the glow relay is designed to turn OFF automatically at coolant temperatures above 21°C (70°F)

  3. Connect a computer with Kubota Diagmaster software to the Engine ECU and check the related signals on the Data Monitor screen to reproduce the DTC conditions

  4. Inspect the wiring harness and connectors between the Engine ECU, the glow plug controller, and the air heater relay for obvious signs of damage, rubbing, or short circuits

Repair steps

  1. Disconnect power

    Turn off the ignition and disconnect the negative battery terminal to prevent electrical shorts during testing.

  2. Isolate the circuit

    Disconnect the main wiring harness connector from the Engine ECU.

  3. Disconnect the relay

    Locate the air heater (glow) relay and disconnect it from its connector.

  4. Test the wiring harness

    Using a multimeter, check for continuity, ground shorts, and +B shorts across the pins of the relay driving circuit, referencing the specific pinout in your model's workshop manual.

  5. Test or replace relay and controller

    If the wiring harness is intact, test the glow plug relay and the glow plug controller. If either component fails to actuate or shows infinite resistance across the coil, replace the faulty component. (Note: Kubota does not approve of wire harness repairs; if the harness is internally shorted, it must be replaced).

  6. Reassemble and clear codes

    Reconnect the ECU and relay. Reconnect the battery. Use the Diagmaster software or the tractor's Intellipanel diagnostic mode to clear the DTC codes.

  7. Verify repair

    Start the engine from a cold state (below 21°C/70°F) to ensure the glow plug light illuminates correctly and the code does not return.

Parts you might need

(4)
  • Glow Plug Controller (Module)

    16415-65660
  • Engine ECU

  • Engine Wiring Harness

Get help to fix this fault by requesting a quote

Browse other Kubota codes