Kubota P0546 – Engine ECU: Exhaust gas temperature sensor 0 (T0) abnormality: Low
Issue description
The Engine ECU has detected a ground short circuit in the sensor or its wiring harness, or a complete failure of the sensor itself. The code is triggered when the exhaust gas temperature sensor (T0) voltage drops to 0.08 V or lower.
Applies to these machines
17 machines- V3307
- V3800
- V2403
- V2607
- D1803
- CR-TE4
- CR-TIE4
- CR-TE5
- SVL75-3
- SVL97
- L3301
- L3901
- L4701
- M5-111
- M6-111
- KX080-4
- Baroness mowers
Check the cause
Verify battery voltage is normal and that the other exhaust gas temperature sensors (T1 and T2) are reading normally.
Locate the T0 sensor (first temperature sensor on the DOC/DPF canisters at the DOC inlet) and visually inspect the wiring for physical connection, damage, or pinching.
Test for a ground short circuit in the sensor or the harness by checking the voltage and resistance at terminals ET0, ET1, ET2, and A-GND3 at the ECU and harness connectors.
Repair steps
Turn the key switch to the "OFF" position.
Locate the Exhaust Gas Temperature Sensor 0 (T0).
Locate the sensor on the exhaust inlet side of the DOC/DPF assembly.
Disconnect the sensor's wiring harness.
Repair the wiring or remove the faulty sensor.
If electrical testing confirms a short in the harness, repair the wiring. If the harness is good but the sensor fails testing (or reads ≤ 0.08 V), remove the faulty T0 sensor from the exhaust pipe.
Install the replacement exhaust gas temperature sensor.
Torque to OEM specifications.
Reconnect the wiring harness.
Clear error codes and verify sensor operation.
Connect a diagnostic tool to the machine's diagnostic port to clear the error codes and verify the sensor is now reading the correct DOC inlet temperature.
Parts you might need
(5)Exhaust Gas Temperature Sensor 0 (T0) / DOC Inlet Temperature Sensor
1J500-18501Exhaust Gas Temperature Sensor 0 (T0) / DOC Inlet Temperature Sensor
1J500-18511
Get help to fix this fault by requesting a quote