P0547

Kubota P0547 – Engine ECU: Exhaust gas temperature sensor 0 (T0) abnormality: High

Issue description

The control unit is reading an abnormally high temperature value from the DOC (Diesel Oxidation Catalyst) Inlet Exhaust temperature sensor. This is typically triggered by an open circuit or a +B (battery voltage) short circuit in the sensor or its wiring harness.

Applies to these machines

  • V2403
  • V2607
  • V3307
  • V3800
  • L3301
  • L3901
  • L4701
  • L3560
  • SVL75
  • SVL90
  • M-series tractors
  • Takeuchi skid steers
  • Baroness mowers

Check the cause

  1. Visually inspect the T0 sensor located at the inlet of the DOC/DPF canisters on the exhaust pipe.

  2. Check the sensor wiring harness for secure connections, chafed wires, open circuits, or a short circuit to battery voltage (+B).

  3. Verify overall battery voltage is normal, as low voltage can sometimes cause erratic sensor readings.

  4. Connect Kubota Diagmaster software to read live exhaust temperature data (T0, T1, T2) and determine if the high reading is permanent or intermittent.

Repair steps

  1. Cool Down

    Ensure the tractor has been turned off and the exhaust system has completely cooled down, as the DPF/DOC canisters reach extreme temperatures during operation and regeneration.

  2. Locate Sensor

    Locate the Exhaust Gas Temperature Sensor 0 (T0) at the inlet of the DOC canister on the exhaust stream.

  3. Disconnect

    Unplug the electrical pigtail connector linking the sensor to the main engine wiring harness.

  4. Remove

    Carefully unscrew the faulty T0 sensor from the exhaust housing.

  5. Install

    Thread the new OEM replacement sensor into the DOC inlet and tighten it to the manufacturer's specified torque.

  6. Reconnect

    Plug the sensor's electrical connector back into the wiring harness.

  7. Clear Codes

    Use the Kubota Diagmaster tool (or an equivalent heavy-duty scanner) to clear the P0547 fault code from the Engine ECU.

  8. Test

    Start the tractor and monitor the live exhaust gas temperature data to ensure the new sensor is reading correctly and the code does not return.

Parts you might need

(4)

Get help to fix this fault by requesting a quote

Browse other Kubota codes