P3011

Kubota P3011 – Engine ECU: Boost pressure low

Issue description

The engine's boost pressure sensor (which uses a piezoelectric resistive effect to monitor air pressure in the intake manifold after the turbocharger compressor) is detecting inadequate air pressure. When this code is triggered, the engine's ECU will enforce an output/speed limitation (insufficient output) and inhibit the DPF parked regeneration process to protect the engine.

Applies to these machines

  • V3800-CR-TE4
  • V3800-TIE4C
  • V3307
  • V2607
  • V2403-CR-TE4B
  • SVL75-3
  • SVL97-3
  • L6060
  • Takeuchi TL6
  • Baroness LM3210A
  • Bobcat loaders

Check the cause

  1. Visually inspect the hose between the turbo blower outlet and the intake flange to see if it is disconnected, loose, or cracked.

  2. Check the air cleaner element for severe clogs or restrictions.

  3. Check the boost pressure sensor and its wiring harness for malfunctions or damage.

  4. Inspect the turbocharger for mechanical damage or exhaust restrictions.

Repair steps

  1. Secure/Replace Hoses

    Reconnect or tighten the hose between the turbo blower out and the intake flange if it has blown off.

  2. Replace Damaged Lines

    If leaks are found, replace the intake hose (after the air flow sensor), the intercooler hose, or the small rubber hose leading to the boost pressure sensor.

  3. Replace Sensor/Turbo

    If the hoses and air filter are intact, replace the faulty boost pressure sensor or damaged turbocharger.

  4. Clear the Code

    Once the physical repair is made, turn the key switch to the "OFF" position. This is the required action for the ECU to recover from the DTC and restore normal engine output.

Parts you might need

(4)

Get help to fix this fault by requesting a quote

Browse other Kubota codes