U0075

Kubota U0075 – Engine Control Unit (ECU / ECM): CAN2 Bus off (Tractor)

Issue description

Communication failure on the CAN2 network (SAE J1939 data link) indicating that the transmitted data is invalid or that communication has stopped entirely. Typically caused by a CAN2 +B (positive) or ground short circuit, an open circuit in the CAN2 B/GND lines, or a high traffic error. This interruption prevents control modules from sharing real-time information, resulting in forced idle (limp mode), loss of throttle response, or sluggish acceleration.

Applies to these machines

  • V3307-CR-TE4
  • V3800-CR-TE4
  • V2403-CR-TE4
  • 07-CR-E5 series
  • MX-Series
  • MX5800
  • MX4800
  • MX5200
  • L-Series
  • L3901
  • M-Series

Check the cause

  1. Verify Preconditions: Ensure the battery voltage is normal and the key switch is in the RUN/ON position. Low voltage can cause false CAN codes.

  2. Clear and Retest (EMI Check): Connect a computer with Kubota Diagmaster software to the CAN1 connector/ECU. Clear the code, cycle the key, and check if U0075 returns to rule out temporary electromagnetic interference (EMI).

  3. Wiring & Connector Check: Inspect the wiring harness and connectors connected to the ECU (specifically the CAN1 and CAN2 connectors) for loose pins, corrosion, or moisture.

  4. Multimeter Voltage/Continuity Test: Test the CAN2 twisted-pair wiring for short circuits (to ground or to 12V positive) and open circuits.

  5. Terminating Resistor Check: Test the two 120-ohm terminating resistors at each end of the network (one at the OEM panel and one near the ECU) to ensure they have not failed open.

Repair steps

  1. Isolate the Fault

    Using your multimeter readings from the diagnostic phase, locate the break or short in the CAN2 twisted-pair wiring. Pay special attention to areas where the harness routes near moving parts or heat sources.

  2. Repair Wiring

    If a pinched, corroded, or broken conductor is found, repair the wiring harness or replace the affected harness section to restore the high-speed data link.

  3. Replace Terminating Resistors

    If the 120-ohm terminating resistor tests out of specification, unplug the faulty resistor from the harness and plug in a new OEM replacement.

  4. ECU Replacement (Last Resort)

    If the wiring harness, connectors, and terminating resistors all test perfectly normal, the CAN transceiver inside the Engine ECU may have failed. The ECU will need to be removed and either sent out for repair or replaced with a programmed unit.

  5. Final Clear

    Reconnect the Diagmaster tool, clear the U0075 code, and run the machine to verify the throttle responds normally and the code does not return.

Parts you might need

(5)
  • CAN Terminating Resistor (120 Ohm)

    3J031-14870
  • Engine Control Unit (ECU / ECM)

    1J802-59052
  • Engine Control Unit (ECU / ECM)

    1H715-60205
  • Wiring Harness

Get help to fix this fault by requesting a quote

Browse other Kubota codes