Massey Ferguson 0.1.63 – Dash Module: Issue With Dash Internal Module Temperature

The internal temperature sensor located on the circuit board inside the instrument cluster has detected a temperature that is outside of normal operating parameters. This can be caused by actual overheating of the module, an electrical short causing excess heat, or a failure of the internal sensor itself.

• 5710SL
• 5711SL
• 5712SL
• 5713SL
• T4
• 4707
• 4708
• 4709
• 4710
• 5608
• 5609
• 5610
• 5611
• 5612
• 5613
• 7614
• 7615
• 7616
• 7618
• 7619
• 7620
• 7622
• 7624
• 7626
• 7714
• 7715
• 7716
• 7718
• 7719
• 7720
• 7722
• 7724
• 7726

1. 1

   Ensure the tractor cab has not been sitting in extreme direct sunlight with the windows closed

2. 2

   Inspect the area around the steering column and instrument cluster for blocked cooling vents or heavy dust/debris buildup

3. 3

   Test the alternator charging voltage to rule out an overcharging alternator causing electronic modules to overheat

4. 4

   Check the wiring harness connecting to the back of the dash for signs of melting, short circuits, or poor grounds

1. 1

   Disconnect Power

   Disconnect the negative battery terminal to prevent electrical shorts during removal.

2. 2

   Remove Trim

   Remove the plastic trim panels and steering column covers surrounding the instrument cluster. (Depending on the model, you may need to lower or remove the steering wheel for clearance).

3. 3

   Extract the Cluster

   Remove the retaining screws holding the instrument panel in place.

4. 4

   Disconnect Harness

   Carefully pull the cluster forward and disconnect the multi-pin wiring harness plugs from the rear of the unit.

5. 5

   Repair or Replace

   Send the defective instrument cluster to an agricultural electronics repair specialist (such as Circuit Board Medics or Ilgenfritz Mechatronics) who can replace the failed internal components on the PCB, or purchase a replacement cluster.

6. 6

   Reinstallation

   Plug the wiring harnesses back into the repaired/new cluster, secure it with the retaining screws, reinstall the trim, and reconnect the battery.