Massey Ferguson 0.2.42 – Dash / Instrument Cluster: Service Counter Issue

Triggered when the tractor's internal maintenance interval counter has either reached its limit (indicating routine service is due) or the system is experiencing a memory/configuration error preventing the counter from functioning or resetting correctly.

• 5710SL
• 5711SL
• 5712SL
• 5713SL
• T4
• 5709 SL

1. 1

   Verify Maintenance Schedule: Check the tractor's hours to determine if a routine service (oil, filters, etc.) is genuinely due.

2. 2

   Attempt a Counter Reset: Use a compatible diagnostic tool (such as Jaltest AGV or AGCO Tech Connect) or the dash menu sequence to attempt a standard service interval reset.

3. 3

   Check for Accompanying Dash Codes: Scan for other dash-related codes (e.g., 00.00.43) which would indicate a deeper configuration loss or hardware failure within the instrument panel itself.

1. 1

   Perform Required Maintenance

   If the tractor is due for service, complete the necessary fluid and filter changes.

2. 2

   Reset the Service Counter

   Connect an AGCO-approved diagnostic tool (or equivalent like Jaltest AGV) to the diagnostic port. Navigate to the Dash/Instrument Cluster module and execute the "Service Counter Reset" command.

3. 3

   Monitor for Code Return

   Cycle the key. If the code clears and does not return, the issue was simply a triggered maintenance reminder.

4. 4

   Replace the Instrument Panel (If Necessary)

   If the diagnostic tool cannot communicate with the dash, the counter refuses to reset, or the dash fails to retain memory after a reset, the instrument panel has suffered a hardware failure. Remove the dash trim, disconnect the wiring harnesses, and install a replacement instrument panel.

5. 5

   Reprogramming

   A new instrument panel will require configuration and programming to match the tractor's serial number and options using AGCO Tech Connect.