Massey Ferguson 0.2.63 – Dash Module: Issue With Dash Internal Module Temperature (Dash)

The internal temperature sensor located inside the dashboard/instrument cluster has detected a temperature that is out of the normal operating range (either overheating due to an internal electrical short, component failure, or extreme ambient cab temperatures).

• 5710SL
• 5711SL
• 5712SL
• 5713SL
• T4
• 4707
• 4708
• 4709
• 4710
• 5608
• 5609
• 5610
• 5611
• 5612
• 5613
• 5709 S
• 5709 SL
• 5710 SL
• 5711 S
• 5711 SL
• 5712 S
• 5712 SL
• 5713 S
• 5713 SL
• 6712 S
• 6713 S
• 6714 S
• 6715 S
• 6716 S
• 6718 S
• 7614 through 7626
• 7714 through 7726
• 8727
• 8730
• 8732
• 8735
• 8737
• 8740

1. 1

   Verify if the tractor has been sitting in direct sunlight with closed windows (ambient heat cause). Ventilate the cab and see if the code clears upon cooling.

2. 2

   Check the instrument cluster for flickering lights, dead gauges, or a cracked display (internal board failure/shorting cause).

3. 3

   Test the battery and alternator charging voltage. An overcharging alternator can send excessive voltage to the dash, causing internal components to overheat.

4. 4

   Inspect the wiring harness connecting to the back of the dash for melted insulation, loose pins, or shorts to ground.

1. 1

   Disconnect Power

   Disconnect the tractor's battery to prevent electrical shorts during removal.

2. 2

   Remove Trim

   Remove the steering column covers and the plastic dashboard trim surrounding the instrument cluster (usually secured by a few Torx or Phillips screws).

3. 3

   Extract the Cluster

   Remove the mounting screws holding the instrument cluster in place.

4. 4

   Disconnect Harnesses

   Carefully pull the cluster forward and unplug the main wiring harness connector(s) from the rear.

5. 5

   Install New Module

   Plug the wiring harness into the replacement instrument cluster and secure it with the mounting screws.

6. 6

   Reassembly

   Reinstall the dashboard trim and steering column covers.

7. 7

   Reconnect & Calibrate

   Reconnect the battery. Note: Depending on the tractor series, a new instrument cluster may require a dealer to plug in their diagnostic laptop (EDT) to sync the tractor's hours, configuration, and CAN BUS network.