Massey Ferguson 00.00.33 – Dash: Clutch Pedal Calibration Issue

The tractor's control system has detected an error or loss of calibration data regarding the clutch pedal's travel limits and position sensor readings.

• 7714
• 7715
• 7715S
• 7716
• 7716S
• 7718
• 7718S
• 7719
• 7720
• 7720S
• 7722
• 7722S
• 7724
• 7724S
• 7726
• 7726S
• Tier 4 (2015-2021)
• 7714S

1. 1

   Ensure gear oil temperature is preheated to a minimum of 50 °C

2. 2

   Secure the vehicle by engaging the handbrake

3. 3

   Ensure the Power Take-Off (PTO) is completely disengaged

4. 4

   Ensure the hand throttle is in the down position (idle run)

5. 5

   Ensure the shuttle control lever is in the 'N' (Neutral) position

6. 6

   Ensure the engine is running

1. 1

   Enter service menu

   With the engine running and pre-conditions met, enter the service menu on the dash by pressing and holding the (A) button.

2. 2

   Navigate menu

   Use the (B) and (C) buttons (arrow symbols) to navigate through the menu.

3. 3

   Select calibration

   Locate and select the 'Clutch pedal calibration' option.

4. 4

   Perform pedal calibration

   Follow the on-screen prompts, which will require you to fully depress the clutch pedal and then release it.

5. 5

   Complete calibration

   The clutch pedal calibration is completed immediately after its release.

6. 6

   Save and exit

   The screen will prompt you to continue to 'Travel clutch calibration'. If you do not want to proceed with that, select the 'SAVE AND EXIT' option and confirm by pressing the (A) button.

7. 7

   Finalize settings

   Ensure the shuttle control lever is returned to the 'N' position to finalize and save the settings.

8. 8

   Re-attempt or replace sensor

   If the dash displays a failure message, the calibration must be re-attempted. If it repeatedly fails, the clutch pedal position sensor is likely faulty and requires replacement.