Massey Ferguson 00.03.45 – Dash: Problem With Dash Configuration

The instrument cluster has an invalid, corrupted, or missing configuration file. When this configuration is lost or corrupted, the dash cannot properly communicate with other modules or display accurate information.

• 7714
• 7715
• 7715S
• 7716
• 7716S
• 7718
• 7718S
• 7719
• 7720
• 7720S
• 7722
• 7722S
• 7724
• 7724S
• 7726
• 7726S
• Tier 4 (2015-2021)
• 7614
• 7615
• 7616
• 7618
• 7619
• 7620
• 7622
• 7624
• 7626
• 5710SL
• 5711SL
• 5712SL
• 5713SL
• 5608
• 5609
• 5610
• 5611
• 5612
• 5613
• 4707
• 4708
• 4709
• 4710
• 5709S
• 6712S
• 8727
• 8730

1. 1

   Check system voltage by testing the battery and alternator, as low voltage or spikes can corrupt module memory (look for related code 00.03.32)

2. 2

   Inspect CAN BUS connections at the rear of the instrument cluster to ensure they are secure and free of corrosion (look for related codes 00.03.3F, 00.03.40, 00.03.44)

3. 3

   Connect the Massey Ferguson Electronic Diagnostic Tool (EDT) to verify the current software version and configuration status of the Dash module

1. 1

   Attempt Reconfiguration

   Using the dealer diagnostic tool (EDT), access the Dash module and attempt to reload the correct configuration file specific to the tractor's VIN and build options.

2. 2

   Software Update

   If the configuration fails to load, attempt to flash the instrument cluster with the latest software update provided by AGCO, then reapply the configuration.

3. 3

   Cluster Removal

   If the dash will not accept the configuration or suffers from an internal memory failure, it must be removed. Disconnect the negative battery terminal. Remove the steering column trim and dashboard bezel. Remove the retaining screws for the instrument cluster and carefully unplug the rear wiring harnesses.

4. 4

   Repair or Replace

   Send the defective unit to a specialized agricultural electronics repair service (such as Ilgenfritz Mechatronics) for internal board repair, or replace it with a new OEM unit.

5. 5

   Install and Program

   Install the repaired or new instrument cluster. Reconnect the diagnostic tool and program the new dash with the tractor's specific configuration file before it will function correctly.