Massey Ferguson 00.03.63 – Dash: Internal Issue With Dash Temperature (Dash)

The internal temperature sensor located on the circuit board inside the instrument cluster is reading a temperature that is out of its normal operating range. This can be caused by the dash module genuinely overheating (due to extreme cab temperatures or an internal electrical short) or a failure of the internal temperature sensor itself.

• 7714
• 7715
• 7715S
• 7716
• 7716S
• 7718
• 7718S
• 7719
• 7720
• 7720S
• 7722
• 7722S
• 7724
• 7724S
• 7726
• 7726S
• Tier 4 (2015-2021)
• 5700
• 6700
• 8700

1. 1

   Verify if the tractor has been sitting in direct, intense sunlight with the windows closed. Allow the cab to cool down, cycle the ignition, and see if the code clears.

2. 2

   Check for other active dash-related voltage codes (such as 00.03.32 or 00.03.61) which could indicate an over-voltage condition or short circuit causing overheating.

3. 3

   Ensure that the cab's HVAC system is not malfunctioning and blowing excessive heat directly behind the dashboard console.

4. 4

   Inspect the main wiring harness connecting to the back of the dash for any melted wires, shorts, or corrosion that could be causing excessive current draw.

1. 1

   Disconnect battery

   Park the tractor on a level surface, turn off the engine, and disconnect the negative battery cable to prevent electrical shorts.

2. 2

   Remove trim panels

   Remove the steering column cowlings and the surrounding plastic dash trim panels to expose the instrument cluster mounting hardware.

3. 3

   Remove retaining screws

   Remove the retaining screws holding the instrument panel in place.

4. 4

   Disconnect harness

   Carefully pull the dash cluster forward and disconnect the multi-pin electrical harness connectors from the rear of the unit.

5. 5

   Inspect connectors

   Inspect the harness connectors for any signs of heat damage or melted pins. If damaged, the connector pigtail must be repaired before installing a new dash.

6. 6

   Connect new dash

   Connect the wiring harnesses to the new replacement instrument panel.

7. 7

   Install new dash

   Mount the new dash cluster and reinstall all trim panels and cowlings.

8. 8

   Reconnect battery

   Reconnect the battery.

9. 9

   Calibrate dash

   A new instrument cluster may require calibration or configuration to the tractor's CAN BUS system using an AGCO dealer diagnostic tool to sync hours and machine options.