Massey Ferguson 00.1.45 – Dash: Problem With Dash Configuration

The instrument panel has either lost its programmed configuration settings, has a corrupted internal memory file, or is detecting a mismatch between its stored configuration parameters and the actual hardware/CAN bus network of the tractor.

• 5710SL
• 5711SL
• 5712SL
• 5713SL
• T4
• 4707
• 4708
• 4709
• 4710
• 5608
• 5609
• 5610
• 5611
• 5612
• 5613
• 7614
• 7615
• 7616
• 7618
• 7619
• 7620
• 7622
• 7624
• 7626
• 7714
• 7715
• 7715S
• 7716
• 7716S
• 7718
• 7718S
• 7719
• 7720
• 7720S
• 7722
• 7722S
• 7724
• 7724S
• 7726
• 7726S

1. 1

   Check battery voltage and inspect the wiring harness/connectors leading to the instrument panel for poor grounds, which can cause temporary memory loss.

2. 2

   Scan for accompanying CAN bus communication codes (such as 00.1.49, 00.1.70, or 00.1.71) to determine if the network is down.

3. 3

   Connect a diagnostic tool (such as AGCO EDT or Jaltest) to read the current parameter values and configuration state of the Dash module to see if the tractor code/model has been wiped or altered.

1. 1

   Connect Diagnostic Tool

   Hook up a compatible diagnostic scanner to the tractor's diagnostic port.

2. 2

   Reconfigure the Dash

   Navigate to the "Parameters" or "Configuration" menu for the Instrument Panel (Dash) module.

3. 3

   Input Tractor Data

   Reload or re-enter the correct tractor configuration parameters (e.g., transmission type like Dyna-4/Dyna-6/Dyna-VT, engine model, and cab options).

4. 4

   Clear Codes and Test

   Save the configuration, clear the fault code memory, and cycle the tractor's ignition key. Check if the 00.1.45 code returns.

5. 5

   Replace if Necessary

   If the Dash module fails to accept the configuration, or if it loses the configuration again after a power cycle, the internal memory (EEPROM) has failed. The instrument panel assembly must be replaced.

6. 6

   Program New Dash

   If replaced, the new instrument panel must be programmed with the correct tractor code and parameters upon its first installation using the diagnostic tool.