Massey Ferguson 00.X.36 – Dash: Issue With Signal Voltage From Gear Shift Lever, T Handle (Dash)

The controller is receiving an erratic, out-of-range, or missing electrical voltage signal from the transmission control lever (the "T-handle") located on the right-hand console or armrest.

• 7714
• 7715
• 7715S
• 7716
• 7716S
• 7718
• 7718S
• 7719
• 7720
• 7720S
• 7722
• 7722S
• 7724
• 7724S
• 7726
• 7726S
• Tier 4 (2015-2021)
• 7700 Series
• 7700S Series
• 7714S
• 7719S
• 7600 Series
• 7614
• 7615
• 7616
• 7618
• 7619
• 7620
• 7622
• 7624
• 7625
• 7626
• 6600 Series
• 6700S Series
• 5600 Series
• 5700SL Series
• 5400 Series

1. 1

   Inspect the electrical connector at the base of the T-handle for loose pins, corrosion, or pushed-out wires

2. 2

   Check the T-handle micro-switches and circuit board for liquid damage, sticky residue, or corrosion from spilled drinks or rain exposure

3. 3

   Using a multimeter, back-probe the T-handle signal wire to verify if the voltage is stuck too high (short to power) or too low (short to ground/open circuit)

4. 4

   Inspect the wiring harness routing from the right-hand console up to the Dash controller for pinch points or chafing

1. 1

   Disconnect Power

   Turn off the tractor and disconnect the negative battery terminal to prevent short circuits.

2. 2

   Access the Console

   Carefully pry up or unbolt the plastic trim panels on the right-hand control console to expose the transmission shift lever assembly.

3. 3

   Disconnect Wiring

   Unplug the wiring harness connector leading to the T-handle.

4. 4

   Remove the Assembly

   Remove the mounting screws/bolts securing the T-handle support base to the console bracket.

5. 5

   Transfer Components (if applicable)

   If you are only replacing the plastic handle or the support base, transfer the internal springs and buttons to the new unit. (Note: It is usually recommended to replace the handle and button assembly as a single unit if the voltage signal is failing).

6. 6

   Reinstall

   Bolt the new T-handle assembly into place, reconnect the wiring harness, and snap the console trim back together.

7. 7

   Test Operation

   Reconnect the battery, start the tractor, and verify that the Dash no longer displays the 00.X.36 code. Test the T-handle by shifting up and down through the Dynashift ratios and ranges.