Massey Ferguson 00.X.3E – Dash: Issue With The Signal Voltage From Forward/Reverse Lever, Low Voltage (Dash)

The control module is receiving a voltage signal from the Forward/Reverse lever that is lower than the expected operating threshold. This usually points to a short to ground, a failing switch internal to the lever, or a wiring harness issue.

• 7714
• 7715
• 7715S
• 7716
• 7716S
• 7718
• 7718S
• 7719
• 7720
• 7720S
• 7722
• 7722S
• 7724
• 7724S
• 7726
• 7726S
• Tier 4 (2015-2021)
• 4700 Series (4707-4710)
• 5600 Series (5608-5613)
• 5700SL Series
• 7600 Series (7614-7626)

1. 1

   Check battery and charging system voltage (must be at least 12.6V when off) to rule out false sensor codes caused by low system voltage

2. 2

   Inspect the wiring harness running down the steering column from the Forward/Reverse lever for chafed wires shorting to the metal column

3. 3

   Unplug the connector at the base of the shuttle lever and check for bent pins, corrosion, or moisture

4. 4

   Perform a switch continuity and resistance test using a multimeter while moving the lever between Forward, Neutral, and Reverse to verify internal switch integrity

1. 1

   Disconnect Power

   Disconnect the negative battery cable to prevent accidental shorts or CAN BUS spikes.

2. 2

   Remove Trim

   Remove the plastic steering column shrouds/covers to gain access to the base of the Forward/Reverse lever on the left side of the steering wheel.

3. 3

   Disconnect Wiring

   Unplug the electrical connector from the shuttle lever switch.

4. 4

   Remove the Lever

   Remove the mounting screws or bolts securing the lever assembly to the steering column bracket.

5. 5

   Install New Part

   Mount the new Forward/Reverse lever assembly and secure the fasteners.

6. 6

   Reconnect

   Plug the electrical connector back in and reinstall the steering column covers.

7. 7

   Clear Codes & Test

   Reconnect the battery. Turn the ignition on and clear the inactive 00.X.3E fault code via the dash menu or a diagnostic tool. Start the tractor and verify smooth engagement into Forward and Reverse.